Century CJW2500X SERIES 소유자 매뉴얼 - 페이지 9

{카테고리_이름} Century CJW2500X SERIES에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Century CJW2500X SERIES 20 페이지. Epa approved high efficiency air tight insert

페이지 인쇄

EXCEPTION (e), page 7:

Masonry or steel, including the damper plate, may be removed from the smoke shelf and

adjacent damper frame if necessary to accommodate a chimney liner, provided that their

removal will not weaken the structure of the fireplace and chimney, and will not reduce protection

for combustible materials to less than required by the National Building Code. Consult with local

building authorities having jurisdiction before starting.

IMPORTANT

WARNING LABEL INSTALLATION

A metal tag has been included with

your fireplace insert. This tag is to be

installed in a visible location on your

fireplace.

Using the 1/4" (6mm) carbide bit, drill

a hole 1" (25mm) into fireplace in the

desired location and hammer lead

anchor down into place. Using pan

head screw supplied, attach tag to

fireplace and tighten until secure.

Tools Required -

NOTES

1) Be sure to remove the protective plastic coating

after installing your insert.

2) Remove screws from insert body, route cord

under body and through the cut out. Attach the

blower with the screws previously removed.

Blower unit should be removed occasionally,

Inspected, and cleaned.

BE SURE TO DISCONNECT POWER

SUPPLY BEFORE SERVICING BLOWER.

3) DO NOT REMOVE

INSULATING MATERIAL

FROM FIRE BOX

BLOWER ASSEMBLY

FAN MOUNTING

SCREWS

P/N S11087- QTY 2

¼" (6mm)

Carbide drill bit

Drill

Screw Driver

P E

see note 2

P/N S31281

SPRING HANDLE

ASSEMBLY

(see page 11 for assembly)

AIR CONTROL

P/N S11008

FACE PLATE

P/N S31296

BRASS TRIM- TOP

*see note 1

P/N S32712

INSERT

3- PRONG GROUNDED PLUG

USE 110VAC- 15AMP

SUPPLY POWER

BRASS TRIM-

ASHFENDER *SEE NOTE

P/N S32062