IKEA IX5HHEXVS00 사용자 지침 - 페이지 8

{카테고리_이름} IKEA IX5HHEXVS00에 대한 사용자 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. IKEA IX5HHEXVS00 40 페이지.

페이지 인쇄

Adtsf

the

Your refrigerator has two adjustable rollers located at the base of

the refrigerator. If your refrigerator seems unsteady or you want

the door to close more easily, use the instructions below.

1. Remove the base grille. Grasp the grille firmly and pull it

toward you.

Using a 3/8"hex driver, turn the roller adjustment screw on

each side to raise or lower that side of the refrigerator.

NOTE: Having someone push against the top of the

refrigerator takes some weight off the adjustment screws and

rollers. This makes it easier to turn the screws. It may take

several turns of the roller adjustment screw to adjust the tilt of

the refrigerator.

•

To raise, turn the roller adjustment screw to the right.

•

To lower, turn the roller adjustment screw to the left.

Turn the brake foot clockwise until it is firmly against the floor

to keep the refrigerator from rolling forward when the freezer

drawer is pulled open.

A. Front roller adjustment

screw

B. Brake foot

Open the door again to make sure that it closes as easily as

you like. If not, tilt the refrigerator slightly more to the rear by

turning both leveling screws clockwise. It may take several

more turns, and you should turn both screws the same

amount.

4. Replace the base grille.

REFRIGERATOR USE

(F_'e_cl_ doo

modes

There are two refrigerator compartment

doors. The doors can be

opened and closed either separately or together.

There is a vertically-hinged

seal on the left refrigerator door.

•

When the left side door is opened, the hinged seal

automatically folds inward so that it is out of the way.

•

When both doors are closed, the hinged seal automatically

forms a seal between the two doors.

A. Hinged seal

The temperature controls are located at the top front of the

refrigerator compartments.

Temperature Controls

For your convenience, the temperature controls are preset at the

factory. When you first install your refrigerator, make sure the

controls are still set to the recommended

setting as shown.

Recommended

Setting "4"

Or*

_ -

--_

off

IM PORTANI"."

The recommended

setting should be correct for normal

household refrigerator use. The controls are set correctly

when milk or juice is as cold as you like and when ice cream is

firm.

Wait 24 hours for your refrigerator to cool completely before

adding food. If you add food before the refrigerator has cooled

completely, your food may spoil.

NOTE: Adjusting the refrigerator and freezer temperature

controls to a colder than recommended

setting will not cool

the compartments

any faster.

If the temperature is too warm or too cold in the refrigerator or

freezer, first check the air vents to be sure they are not

blocked before adjusting the controls.