Airflow Uno hab 설치 및 운영 지침 매뉴얼 - 페이지 11
{카테고리_이름} Airflow Uno hab에 대한 설치 및 운영 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Airflow Uno hab 16 페이지. Cavity wall decentralised mechanical ventilation with heat recovery unit
Airflow Uno hab에 대해서도 마찬가지입니다: 지침 (2 페이지), 설치 키트 (16 페이지), 유지 관리 매뉴얼 (2 페이지)
페이지 인쇄m
WARNING
m
CAUTION
© Airflow - we reserve the right to make changes without prior notice
6.2
Cleaning the heat accumulator and protection guard
m WARNING!
The unit must be isolated from the mains power supply before any maintenance and installation work or
before opening the terminal compartment!
The Unohab heat accumulator consists of an easy-to-clean ceramic stone. The ceramic heat accumulator can be
rinsed with water as part of the regular overall maintenance of the ventilation unit. Proceed as follows:
1. Remove entire inner panel from the wall or from the wall installation sleeve (fig.17).
2. Remove the 2-part connector (fig.18) and detach.
Remove
inner panel
3. Pull the fan unit from the wall installation sleeve using the pull-out tool (fig.19).
4. Remove lip seals (fig.20).
5. Remove the top EPP half shell labelled "TOP" (fig.20).
Fan unit
6. Remove ceramic heat accumulator from the EPP-half-shell (fig.21) for cleaning.
m
CAUTION!
Carefully remove the foam sealing tape (fig.21) before cleaning!
– rinse under warm water
Ceramic heat
accumulator
Protection
guard
Unohab Unit
fig.17
fig.19
Pull-out tool
11
Installation and Operating Instructions
Remove
connector
Connection cable not pictured!
"TOP"
Lip seal
Foam sealing tape
mRemove before cleaning!
Protection
guard
fig.18
fig.20
fig.21