Century ES-8500 사용자 설명서 - 페이지 5
{카테고리_이름} Century ES-8500에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Century ES-8500 8 페이지. Portable power source
페이지 인쇄CHECKING
POWER
LEVEL
Check power level of the Portable Power
Source with the test button.
Lights will
come on in sequence from empty to the
charged light. The CHARGED LIGHT will
come on when the test button is
depressed and the Portable Power
Source has a full charge.
RECHARGING
THE
PORTABLE
POWER
SOURCE
Note:
There are two ways to charge the
portable power source. The first
method is automatic charging
with the provided wall charger
(preferred). The second is
through the 12 Vdc power
receptacle using the power
charging cord. The second
method is not automatic and
requires watching because the
portable power source could be
damaged due to overcharging.
The second method will only
charge one of the two batteries in
the ES-8000 & ES-8500, so it is
not recommended for these units.
1. With the wall charger. The portable
power soume is automatically
charged using the wall charger. A
CHARGING JACK (found on the
front of your portable power source)
is connected through a smart circuit
board to the portable power source
making recharging automatic. If
your Portable Power Soume is
completely discharged, it may take
up to 30 hours for recharging,
Overcharging is not a problem
when using the wall charger and
the portable power source can be
left connected to the wall charger
indefinitely.
a. Insert the wall charger plug (see
6, Figure 1) into the CHARGING
JACK (mounted on the front of
the portable power source)
b. Connect the wall charger AC/
DC ADAPTOR to the ac outlet
(the CHARGING
light will light).
c, Allow the portable power source
to charge until the CHARGED
light comes on (you can monitor
the progress by checking the
red POWER LEVEL lights -
when all three POWER LEVEL
lights are lit the CHARGED light
should eventually come on).
d. Once the CHARGED
light
comes on, charge another three
to six hours, (three hours is
acceptable but to ensure
maximum output capability, six
hours is preferred).
e,
If you are not going to need the
portable power source right
away you may leave the wall
charger connected to the
portable power source. We
recommend that the wall
charger remain connected to the
portable power source when-
ever the portable power source
is not in use.
2.
With the Optional Charging Cord.
Start the vehicle engine. Plug one
end of the power extension cord
into the portable power source
power receptacle and the other end
into a vehicle lighter outlet. Press
the test button once every hour to
check the POWER LEVEL. When
all of the red lights and the charged
light come on, charge the portable
power source another 1 to 2 hours
to insure a complete recharge. DO
NOT OVERCHARGE!
This is NOT
an automatic method of charging
the portable power source. You
must frequently monitor the
charging process (POWER LEVEL
indicators by pressing the TEST
button) to ensure the portable
power soume is not overcharged.
Ovemharging with this method will
damage your portable power
source.
Note:
Test button needs to be pressed
to check power level and charged
light.