Airflow 90001253 매뉴얼 - 페이지 3

{카테고리_이름} Airflow 90001253에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Airflow 90001253 7 페이지.

1 . G e n e r a l I n f o r m a t i o n

To ensure complete and effective operation, and for your own safety, all the following instructions should be

read carefully and observed. The relevant national standards, safety regulations, instructions and actions

required by law as well as the technical connection conditions of the energy supply company must be

observed and applied. Keep the Installation and Operating Instructions as a reference. After the final

assembly, the document must be handed out to the operator (tenant/owner).

Warning:

1.1

Safety instructions will be presented in a box such as this. All information must

be followed and adhered to. To not do so will or could result in a dangerous situation.

1.2 Warranty and Liability claims

To safeguard the guarantee and liability claims of the customer, the following must be observed:

Implementation according to "unit" Installation and Operating Instructions. The use of accessories, which are

not approved, recommended, or offered by Airflow Developments, is not permissible. Any damages are

excluded from the guarantee. If these instructions are not observed, all warranty claims are excluded. This

also applies to any liability claims extended to the manufacturer.

1.3 Regulations - Guideline

If the product is installed correctly and used to its intended purpose, it conforms to all applicable regulations

including UKCA and CE guidelines at its date of manufacture.

1.4 Receipt

Please check delivery immediately on receipt for accuracy and damage. If damaged, please notify the carrier

immediately. In case of delayed notification, any possible claim may be void.

1.5 Storage

When storing for a prolonged time, the following steps are to be taken to avoid damaging influences:

Protection by dry, air-dustproof packing (plastic bags with drying agent and moisture indicators). The storage

place must be waterproof, vibration-free, and free of temperature variations. Damages due to improper

transportation, storage or commissioning must be verified and are not liable for warranty.

1.6 Intended use

The control element is intended for controlling the MultiPlexBox. It is not a ready-to-use product and it may

only be operated once the ventilation system has been properly installed and connected. The controller is

designed for flush mounting in an empty socket with a diameter of 68mm. Any use other than the intended

use is prohibited.

1.7 Disposal

An authorised specialist waste processing company must dispose of the unit or the individual components.

The appointed contractor must ensure that:

– The components are separated according to material types.

– The used operating materials are sorted and separated according to their respective properties.