IKEA 302-371-38 매뉴얼 - 페이지 15
{카테고리_이름} IKEA 302-371-38에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. IKEA 302-371-38 44 페이지.
IKEA 302-371-38에 대해서도 마찬가지입니다: 매뉴얼 (44 페이지)
페이지 인쇄
ENGLISH
If you operated the appliance
wrongly, or the installation was
not carried out by a registered
engineer, the visit from the After
Sales Service technician or
dealer may not take place free
of charge, even during the
warranty period.
Installation
General information
Manufacturer is not responsible for any
injury to persons and pets or damage to
property caused by failure to comply
following requirements.
Caution! To proceed with the
installation refer to the assembly
instructions.
Warning! Installation process
must follow the laws, ordinances,
directives and standards
(electrical safety rules and
regulations, proper recycling in
accordance with the regulations,
etc.) in force in the country of use!
Warning! The appliance must be
earthed!
Warning! Risk of injury from
electrical current.
• The electrical mains terminal is live.
• Make electrical mains terminal free of
voltage.
• Loose and inappropriate plug and
socket connections can make the
terminal overheat.
• Have the clamping connections correctly
installed.
• Use strain relief clamp on cable.
• Follow the connection diagram (it is
located on the underneath surface of the
casting of the hob).
Important!
• You must observe the minimum distances
to other appliances and furniture
cabinets or other units according to
Assembly Instruction.
• If there is no oven beneath the hob insert
a dividing panel at a minimum distance
of 20 mm from the bottom of the hob.
• Protect the cut surfaces of the worktop
against moisture using a suitable sealant
included in the product in fitting bag. The
sealant seals the appliance to the work
top with no gap.
• Do not use silicon sealant between the
appliance and the worktop. Avoid
installing the appliance next to doors
and under windows as hot cookware
may be knocked off the rings when doors
and windows are opened.
• Only an authorized service engineer can
install, connect or repair this appliance.
Use only original spare parts.
Electrical connection
• Before connecting, check that the
nominal voltage of the appliance stated
on the rating plate, corresponds to the
available supply voltage. Also, check the
power rating of the appliance and
ensure that the wire is suitably sized to
suit the appliance power rating (refer to
the Technical information chapter). The
15