IKEA 905.348.52 매뉴얼 - 페이지 9
{카테고리_이름} IKEA 905.348.52에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. IKEA 905.348.52 32 페이지.
페이지 인쇄
ENGLISH
General information
General recommendations
• Never use scouring pads, steel wool, muriatic
acid or other products which could scratch or
mark the surface.
• For safety reasons, do not clean the appliance
with steam blasters or high-pressure cleaners.
• Foods that accidentally fall or settle on
the surface, on the functional or aesthetic
elements of the hob must not be eaten.
Cabinet requirements
• The cooking hob is intended to be built into
the worktop above a kitchen cabinet of 800
mm width or more.
• If fitting in flammable material, the guidelines
and standards for low voltage installations
and for the fire protection must be strictly
observed.
• For fitted units, the components (plastic
materials and veneered wood) must be
assembled with heat-resistant adhesives (min.
85°C): Unsuitable materials and adhesives can
result in warping and detachment.
• The kitchen cabinet must allow sufficient
room for the electrical connections of the
appliance. Suspended kitchen cabinets above
the appliance must be installed at a distance
that provides enough room for comfortable
working process.
• The use of hard wood decorative borders
around the worktop behind the appliance is
allowed, in this case the minimum distance
remains as indicated on the installation
illustrations.
• Positioning and dimensions of the cut-out for
built-in appliance is shown in the illustration
below. The measurements shown are
only valid if the following condition is met:
worktop overhang to cabinet front is 35mm.
• Minimum distance between built-in appliance
and any cabinet above it is 500mm.
+2
773
mm
+2
490
mm
555 mm
18 - 40mm
• To prevent leakage of liquid between the
edge of the hob and the countertop, place
the adhesive seal provided along the entire
outer edge of the hob before assembly.
Please refer to Assembly Instruction.
Use
• The extractor appliance has been designed
exclusively for domestic use to eliminate
kitchen smells.
• Never use the appliance for purposes other
than for which it has been designed.
• Deep fat fryers must be continuously
monitored during use: overheated oil can
burst.
• Do not operate the appliance with an
external time switch or a separate remote
control system.
• The appliance shall not be installed behind a
decorative door in order to avoid overheating.
• To avoid damaging the appliance, do not
climb onto the appliance.
• To avoid damaging the silicon grouting, do
not put hot cookware on the frame.
• Do not cut or prepare food on the surface
or drop hard objects onto it. Do not drag
cookware across the surface.
Min. 500 mm
9