IKEA ALMESTAD 매뉴얼 - 페이지 6

{카테고리_이름} IKEA ALMESTAD에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. IKEA ALMESTAD 33 페이지.

페이지 인쇄

Model and Serial Number Location

The rating plate is located under the cooktop.

When ordering parts for or making inquires about

your cooktop, always be sure to include the model

and serial numbers and a lot number or letter from

the rating plate on your cooktop.

Rating plate is

located under

the burner box of

cooktop.

Important Notes to the Installer

1. Read all instructions contained in these installa-

tion instructions before installing the cooktop.

2. Remove all packing material before connecting

the electrical supply to the cooktop.

3. Observe all governing codes and ordinances.

4. Be sure to leave these instructions with the con-

sumer.

5. Only certain cooktop models may be installed

over certain built-in electric oven models. Ap-

proved cooktops and built-in ovens are listed by

the MFG ID number and product code.

6. All materials used in construction of cabinets,

enclosures, and supports surrounding the prod-

uct must have a temperature rating above

194°F(90°C).

Important Note to the Consumer

Keep these instructions with your Use and Care

Guide for future reference.

IMPORTANT SAFETY

INSTRUCTIONS

•

Be sure your cooktop is installed and

grounded properly by a qualified installer

or service technician.

•

This cooktop must be electrically grounded

in accordance with local codes or, in their

absence, with the National Electrical Code

ANSI/NFPA No. 70—latest edition in the

United States.

WARNING!

The electrical power to the cooktop must

be shut off while line connections are

being made. Failure to do so could result

in serious injury or death.

Provide Electrical Connection

Install the junction box under the cabinet and run

120/240 or 120/208 Volt, AC wire from the main

circuit panel.

NOTE: DO NOT connect the wire to the circuit panel

at this time.

Electrical Requirements

Observe all governing codes and local

ordinances.

1. A 3-wire or 4-wire single phase 120/240 or

120/208 Volt, 60 Hz AC only electrical sup-

ply is required on a separate circuit fused on

both sides of the line (time-delay fuse or circuit

breaker is recommended). DO NOT fuse neutral.

2. A circuit breaker or fuse rated at 40 Amp is

required for 36" models and 30 Amp for the 30"

model.

NOTE: Wire sizes and connections must conform

with the fuse size and rating of the appliance in

accordance with the National Electrical Code ANSI/

NFPA No. 70–latest edition and local codes and

ordinances.

WARNING!

An extension cord must not be used with

this appliance. Such use may result in a

fire, electrical shock, or other personal

injury.

3. The appliance should be connected to the fused

disconnect (or circuit breaker) box through

flexible armored or nonmetallic sheathed cable.

The flexible armored cable extending from this

appliance should be connected directly to the

grounded junction box. The junction box should

be located as shown in Figure 2 with as much

slack as possible remaining in the cable between

the box and the appliance, so it can be moved if

servicing is ever necessary.

4. A suitable strain relief must be provided to at-

tach the flexible armored cable to the junction

box.

AA-2328606-1