Green image GC-2103DMX-S 빠른 시작 매뉴얼 - 페이지 3
{카테고리_이름} Green image GC-2103DMX-S에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Green image GC-2103DMX-S 4 페이지. Dmx512 decoder
페이지 인쇄Using Instruction
Operation
Use the following buttons to set desired DMX512 address: "1" sets
"hundredths" position, "2" sets "tenths" position, "3" sets "ones".
Ensure a stable connection for the DMX512 controller to work properly.
Choose Channel
Press 2
and 3
button at the same time for 2 seconds, digital display
nd
rd
will flash cH, then press 1
st
to how many desired channels (3 creates 3 channels, and so on). Press
and hold any button for >2 seconds to confirm 1,2,3 or 4 channels.
The factory preset default is 4 channel outputs.
Choose Mode
Press 1
and 2
key for 2 seconds, digital display will flash "r , u".
st
nd
Press 3
button to choose between mode 1 or 2. If the board displays
rd
ru1: stand-alone mode; ru2: slaver mode. Press any button for 2
seconds to confirm the selected mode.
Operation under DMX 512 SLAVE mode
Under mode ru2 will function as standard DMX512 decoder slave, it can
connect to a DMX512 MASTER signal with DMX512 signal input port, to
be controlled by DMX512 master. Set desired DMX512 address and the
digital numeric interface will display the starting address.
For example, if the digital numeric displays 001, it means this DMX
slave has the 001,002,003,004 addresses (under situation of 4 CH).
Operation under STAND-ALONE mode
Under stand-alone mode ru1, it can be operated as an independent LED
controller that cannot accept DMX input.
In stand-alone mode, it is an individual LED controller with no DMX in or
out. The function is as follows: If ru1 is selected, press any button >2
seconds to confirm, the three buttons on board will have new functions
like the diagram to the right.
Choose Channel
Hold the "Brightness" and "Mode" button for two seconds, when cH
digital display flashes, press "Speed" button to choose '3' or '4', then
press any button for 2 seconds to confirm desired channels.
greenimagetech.com
105 8288 N Fraser Way
Burnaby BC, V3N 0E9
button to choose 1/2/3/4, each corresponds
T: (604) 207-9879
F: (604) 207-6992
1
2
Stand-Alone mode:
Denoted by "ru1"
© Green Image Tech, LTD. All rights reserved. We reserve the right to change design, materials
and finish in any way that will not alter installed appearance or reduce function and performance.
GC-2103DMX-S
DMX512 Decoder
(with Stand-Alone)
"3" button
"2" button
"1" button
3
"Brightness" button
"Modes" button
"Speed" button