Gantner Q Series 매뉴얼 - 페이지 9

{카테고리_이름} Gantner Q Series에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Gantner Q Series 17 페이지.

4.1

4.2

4.3

Prerequisites

The ARINC429 Specification defines the standard requirements for the

transfer of digital data between avionics systems on commercial aircraft.

ARINC429 is also known as the Mark 33 DITS Specification. Signal levels,

timing and protocol characteristics are defined for ease of design

implementation and data communications on the Mark 33 Digital

Information Transfer System (DITS) bus.

With the ARINC 429 plugin (GInsARINCPlugin) you can connect a Q.series

system to an ARINC 429 avionics data bus. The GInsARINCPlugin is an

extension that adds support for the AIM ASC429-x USB 2.0 SmartCable™ to

the Q.station.

Figure 4-1 AIM ASC429-x USB 2.0 SmartCable™

Input channels from the ARINC 429 data bus can be written to the

Q.station's virtual variables, which allows for recording and sampling

ARINC bus data in conjunction with Q.series measurement data.

This manual describes the setup, configuration and operation of the

GInsARINCPlugin using the test.commander and GI.monitor software

programs. The general setup and operation of your system is described in a

separate manual.

You will find this manual also as a PDF file on our website page

www.gantner-instruments.com.

Q.station, Q.raxx station or Q.brixx station



Q.station firmware 2.11 B04 or later



GI.monitor version 1.2 or later



Version no. 1.0

Released February 12, 2018