IKEA KULINARISK 사용자 설명서 - 페이지 25

{카테고리_이름} IKEA KULINARISK에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. IKEA KULINARISK 36 페이지. Oven with steam feature
IKEA KULINARISK에 대해서도 마찬가지입니다: 사용 설명서 (20 페이지), 사용자 설명서 (36 페이지), 사용자 설명서 (16 페이지), 사용자 설명서 (36 페이지), 사용자 설명서 (32 페이지), 매뉴얼 (36 페이지), 사용 설명서 (48 페이지), 사용 설명서 (36 페이지), 매뉴얼 (24 페이지), 설치 지침 매뉴얼 (36 페이지), 매뉴얼 (20 페이지), 매뉴얼 (44 페이지), 매뉴얼 (40 페이지), 매뉴얼 (40 페이지), 사용자 설명서 (20 페이지), 매뉴얼 (37 페이지), 매뉴얼 (32 페이지), 빠른 시작 매뉴얼 (16 페이지), 매뉴얼 (20 페이지), 매뉴얼 (20 페이지), 매뉴얼 (36 페이지), 매뉴얼 (21 페이지), 빠른 시작 매뉴얼 (8 페이지), 매뉴얼 (40 페이지), 매뉴얼 (20 페이지), 매뉴얼 (32 페이지), 매뉴얼 (36 페이지), 매뉴얼 (17 페이지)

페이지 인쇄

ENGLISH

generator. Wait for approximately 10

minutes.

2. Remove the water and vinegar with the

sponge.

3. Put clean water (100 - 200 ml) into the

water drawer to flush the steam

generation system.

4. Remove the water from the steam

generator with the sponge and rub it

dry.

5. Keep the door open to let the appliance

dry fully.

Removing and installing the door

You can remove the door and the internal

glass panels to clean it. The number of glass

panels is different for different models.

Warning! The door is heavy.

1. Open the door fully.

2. Fully press the clamping levers (A) on

the two door hinges.

3. Close the oven door to the first opening

position (approximately 70° angle).

4. Hold the door with one hand on each

side and pull it away from the oven at

an upwards angle.

5. Put the door with the outer side down

on a soft cloth on a stable surface.

6. Hold the door trim (B) on the top edge

of the door at the two sides and push

inwards to release the clip seal.

7. Pull the door trim to the front to remove

it.

8. Hold the door glass panels on their top

edge one by one and pull them up out

of the guide.

9. Clean the glass panel with water and

soap. Dry the glass panel carefully.

When the cleaning is completed, do the

above steps in the opposite sequence.

Install the smaller panel first, then the larger

and the door.

One of the hinge-arms (normally

the right one) is free to move.

Make sure, that both hinge-arms

are in the same position

(approximately 70° angle).

Warning! Make sure that the

glasses are inserted in the correct

position otherwise the surface of

the door may overheat.

Replacing the lamp

Put a cloth on the bottom of the interior of

the oven. It prevents damage to the lamp

glass cover and the cavity.