Britax Click & Go 빠른 시작 매뉴얼 - 페이지 2

{카테고리_이름} Britax Click & Go에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Britax Click & Go 2 페이지. Agile receiver
Britax Click & Go에 대해서도 마찬가지입니다: 사용 설명서 (16 페이지)

페이지 인쇄
Britax Click & Go 빠른 시작 매뉴얼
HOW TO FIT
2
2
Fit the Britax Stroller Click & Go Adaptors to the Safe-n-Sound
Unity Infant Carrier.
Please refer to Britax Stroller Click & Go Adaptors Instructions for
the correct installation of the adaptors.
TO INSTALL THE INFANT CARRIER INTO
STROLLER
IMPORTANT: These Instructions are for installing and
removing the Infant Carrier on the stroller only. For Installing
of the Infant Carrier in the car please follow the Instruction
book included with the Infant carrier.
3
Carry
Position
3
With the Infant Carrier handle in the "carry position", place the
Britax Stroller Click & Go Adaptor on each side directly over the
Agile Click & Go Receivers and push down.
4
Rocking
Position
4a
4
To secure the Carrier to the stroller rotate the handle to the "non
rocking position", To do this:
a. Squeeze the carry handle release latch on each side of the
handle and rotate to the "rocking position"
b. Squeeze the latch again and start to rotate the handle then
remove both hands from the latches and use one hand at
the top of the handle to rotate down further until the handle
latches in the "non-rocking position". The carrier is now
locked to the stroller. Pull up on carrier to ensure it is locked
in position.
4a
4b
Push down until it clicks into place.
Non-rocking
Position
4b