Airflow DUPLEX RS5 1500/ 700 조립 매뉴얼 - 페이지 2

{카테고리_이름} Airflow DUPLEX RS5 1500/ 700에 대한 조립 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Airflow DUPLEX RS5 1500/ 700 16 페이지. Air-handling units

Dear customer,

Thank you for choosing our product and we hope that you will be fully satisfied.

This manual contains all necessary instructions, information, hints and recommendations for safe and

correct equipment installation and commissioning. Please read the manual carefully and follow the

instructions contained herein.

Symbols explained

Items or sections marked with  (or with a grey background) apply only to ventilation units

manufactured in compliance with the hygienic requirements of Regulation VDI 6022 (indicated on the

identification plate, see following chapters).

Important notices

●

Electrical connections, commissioning and adjustment of the appliance may only be

carried out by qualified electrical engineers.

●

Before the installation and commissioning of the appliance carefully read the installation,

use and maintenance manual, the controller operation manual and, where applicable, the

service documentation.

●

The appliance and all its accessories must be installed and used in compliance with the

design, technical conditions specified by the manufacturer and applicable legislation and

technical standards in effect.

●

The appliance may not be installed and operated in an aggressive environment that could

damage its external and internal mechanical parts.

●

Before putting the appliance into permanent operation an initial inspection report on the

appliance´s power supply must be provided.



Before putting the appliance into operation an approval test (see VDI 2079 and DIN EN

V 12599) of the entire HVAC system of which the appliance forms part must be conducted.

The test must include the examination of hygienic requirements as per VDI 6022 and must

be documented. The user must be able to present the approval test report at any time. If the

above requirements are not met, the manufacturer cannot ensure compliance with hygienic

requirements.

The manufacturer is not liable for any damage caused by

●

unprofessional installation and operation that is not in compliance with the operation and

maintenance manual and general practices applied during installation and operation of

HVAC equipment and control systems.

●

using the equipment to other purposes than stated in the Chapter 3.2 Intended use.