Bernard Burton Spirit of Pitts 조립 설명서 - 페이지 3

{카테고리_이름} Bernard Burton Spirit of Pitts에 대한 조립 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Bernard Burton Spirit of Pitts 11 페이지.

Fuse:

Step 1: Prepare the fuse sides S1.

Glue the 3 fuse side sections together. Use a long straight edge to assure alignment

along top edge.

Glue the front side doubler S2 on S1 with 30' epoxy and let the epoxy cure.

Note: Be sure that you prepare one right side and one left side.

Step 2: Glue the former doubler F2a on F2 with 30' epoxy. The second F2 former does not

require to be doubled. Let the epoxy cure.

Step 3: Build crutch assembly, upside down, on a flat workbench. We can not emphasize enough

the importance of building this crutch square and also the alignment to the print. (This is

as important as building a straight wing). The flat surface of the formers should be placed

on the workbench.

Glue with 30' epoxy the formers F5, F2, F2' (doubled), F3 and F4 on their respective

places on the fuse sides S1. Be sure your start with F5 first. Verify and eventually adjust

the alignments and let the epoxy cure.

DRAFT