Airflow DUPLEX RS5 3500/1200 조립 매뉴얼 - 페이지 9

{카테고리_이름} Airflow DUPLEX RS5 3500/1200에 대한 조립 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Airflow DUPLEX RS5 3500/1200 16 페이지. Air-handling units

●

Slope both the longer and shorter side of the casing 3% towards the condensate drain K1 in the

compartment e2/ c2 (SUP/IDA)

Position of condensate drains, top view (floor plan)

4.4.

Connecting ductwork

●

Connect the HVAC duct following the design documentation. Make sure that the air exhausted at

i2 does not return back to the fresh air supply e1.

●

Air duct must be connected to both inlet ports in a way that a uniform air speed profile is achieved

in the whole cross-section of inlet ports.

●

A straight air duct being at least 1 m long must be firmly connected to extraction ports to achieve a

uniform air speed profile in the whole cross-section of extraction ports.

A duct being at least 2 m long must be always connected to fan outlets to prevent injury caused by

the fan's impeller. This duct must be connected in such a way that it can be dismantled only by using

tools.

4.5.

●

The unit is equipped by two condensate outlets; these are used depending on whether an integrated

cooler is installed.

Use of condensate drains, integrated

cooler is installed

Use of condensate drains, integrated

cooler is not installed