ENGLISH
2. Keep the knob pushed for about 5 sec;
this will allow thermocouple to heat up,
and the safety device to switch off, oth-
erwise the gas supply would be inter-
rupted.
3. After the flame is regular, adjust it as
preferred.
If after a few attempts the burner does
not ignite, check that the crown and its
cap are in correct positions.
Burner cap
1
Burner crown
2
Injector
3
Thermocouple
4
Ignition candle
5
Warning! Do not keep control knob
pressed for more than 15 seconds.
Helpful hints and tips
Energy savings
• If possible, always place lids on the pans.
• As soon as liquid starts boiling, turn down
the flame to barley keep the liquid sim-
mering.
Use pots and pans with bottom fitting the
size of burner used.
Care and cleaning
Warning! Switch the appliance off and
let it cool down before you clean it.
If the burner does not light after 15 seconds,
release the control knob, turn it into off posi-
tion and wait for at least 1 minute before
trying to light the burner again.
Important! In the absence of electricity You
can ignite the burner without electrical
device; in this case approach the burner
with a flame, push the relevant knob down
and turn it counter-clockwise to maximum
gas release position.
Warning! Maintain extreme caution
while operating with open fire in
kitchen environment. Manufacturer declines
1
any responsibility in case of misuse of flame.
2
If the burner accidentally goes out, turn
the control knob to the off position and
wait for at least 1 minute before trying to
3
light it again.
4
When switching on the mains, after in-
stallation or a power cut, it is quite nor-
5
mal for the spark generator to be activated
automatically.
Turning the burners off
To put the flame out, turn the relevant con-
trol knob to the symbol
Warning! Always turn the flame down
or switch it off before removing the
pans of the burner.
Burner
Ultra-
rapid
The bottom of the cookware should be as
thick and flat as possible.
.
minimum di-
maximum di-
ameter of
pots and pans
pots and pans
160 mm
6
ameter of
260 mm
페이지 인쇄