ENGLISH
Problem
symbol plus a number
appears on the power set-
ting display.
lights up on the power
setting display.
If there is an error, first try to find a solution
to the problem yourself. If you cannot find a
solution to the problem yourself, contact
your dealer or the After Sales Service.
Installation
General information
Manufacturer is not responsible for any
injury to persons and pets or damage to
property caused by failure to comply
following requirements.
Caution! To proceed with the
installation refer to the assembly
instructions.
Possible cause
Electronic component error.
Overheating protection for
the cooking zone operates.
Remedy
Disconnect the appliance
from the electrical supply for
a few minutes. Remove the
fuse, wait one minute, and
insert the fuse again.
Deactivate the appliance.
Remove the hot cookware.
After approximately 30 sec-
onds activate the cooking
zone again.
appear, residual heat indi-
cator can stay. Cool down
the cookware and check it
with the section "Cookware
for the induction cooking
zones".
If you operated the appliance
wrongly, or the installation was
not carried out by a registered
engineer, the visit from the After
Sales Service technician or
dealer may not take place free
of charge, even during the
warranty period.
Warning! Installation process
must follow the laws, ordinances,
directives and standards
(electrical safety rules and
regulations, proper recycling in
accordance with the regulations,
etc.) in force in the country of use!
Warning! The appliance must be
earthed!
Warning! Risk of injury from
electrical current.
15
should dis-
페이지 인쇄