Gantom TL283 사용자 설명서 - 페이지 2

{카테고리_이름} Gantom TL283에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Gantom TL283 10 페이지.

POWER AND WIRING REQUIREMENTS

The Gantom Juni has a maximum wattage of 9W and and requires 12VDC power. This fixture is

compatible with dimmable 12VDC constant voltage LED drivers. Generally, PWM dimmers which work

with 12VDC LED tape will also work with the Juni. Here is a diagram showing how this fixture could be

connected to a 0-10VDC dimmer switch:

The Gantom Juni has bare wires for power input, and includes a screw terminal adapter which allows

you to connect the fixture to a standard 2.1mm DC barrel jack.

BARE WIRE PINOUT

RED

Power

BLUE

Note: all fixtures must be installed with the low voltage supply power OFF. Hot

plugging (connecting to a live power supply) is not supported.

Hot plugging a fixture into a system with a running power supply will increase the load on the power

supply, which can generate voltage spikes that more than double of the standard input voltage. This

causes an out-of-spec and out-of-warranty voltage condition which may result in damage to the fixture.

While Gantom fixtures have internal protections against voltage spikes, it is recommended that

installers handle them with care to prevent these spikes from happening in the first place.

Installing all fixtures in the system before turning on power to the low voltage

power supply assures that the power supply has a "soft start" which is free from

harmful voltage spikes.

Gantom Juni User Guide

Version 1.0 – 3/31/2021