IKEA BEJUBLAD 사용 설명서 - 페이지 9

{카테고리_이름} IKEA BEJUBLAD에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. IKEA BEJUBLAD 24 페이지. Ikea oven
IKEA BEJUBLAD에 대해서도 마찬가지입니다: 사용자 설명서 (28 페이지), 매뉴얼 (24 페이지), 매뉴얼 (48 페이지), 매뉴얼 (16 페이지), 사용 설명서 (36 페이지), 매뉴얼 (8 페이지), 매뉴얼 (41 페이지), 매뉴얼 (20 페이지), 매뉴얼 (32 페이지)

페이지 인쇄
IKEA BEJUBLAD 사용 설명서
ENGLISH

Control panel

A
A
Selection knob
B
Light
Setting the timer
C
D
Display
Adjustment buttons
E
F
Thermostat knob

First use

Remove the accessories from the oven and
heat it at 200° for about an hour to eliminate
the smell and fumes from the insulating
materials and protective grease.
Turn on/off the oven
To switch on the oven turn the
desired function, to switch off turn the
to position "0".
Setting the time
You will need to set the time when you switch
on the appliance for the first time: Press
until the icon
and the current time start

Daily use

Select a function
To select a function, turn the selection
to the symbol for the function you require: The
display will light up and an audible signal will
sound.
Activate a function
MANUAL
To start the function you have selected, turn
the thermostat knob to set the temperature
you require.
B C
D
A
Knob to the
A
knob
A
knob
E
F
Retractable knobs
To use this type of knob, press it in the middle.
The knob comes out.
Turn it to the required position.
Once cooking is over, turn the knob to
press it again to restore it to its original
position.
flashing on the display.
–
Use
+
or
confirm.
The two digits for the minutes will start
flashing. Use
+
to confirm.
press
Please note: When the icon is flashing, for
example following lengthy power outages, you
will need to reset the time.
Please note: During cooking you can change
the function by turning the selection knob
or adjust the temperature by turning the
thermostat knob.
The function will not start if the thermostat
knob is on 0 °C.
You can set the cooking time, cooking end time
(only if you set a cooking time) and a timer.
Preheating
Once the function has been activated, an
audible signal and a flashing icon
display indicate that the preheating phase has
been activated.
to set the hour and press
–
or
to set the minutes and
9
and
to
on the