Ceotis COB-BEL-135-VG 설치 매뉴얼

{카테고리_이름} Ceotis COB-BEL-135-VG에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Ceotis COB-BEL-135-VG 2 페이지. Led high bay

- THE PRODUCT MUST BE INSTALLED BY A QUALIFIED ELECTRICIAN.

- THE POWER SUPPLY MUST BE TURNED OFF BEFORE INSTALLATION.

- NO WARRANTY WILL BE ACCEPTED IF THIS PRODUCT IS NOT INSTALLED BY A QUALIFIED

ELECTRICIAN.

- THE LIGHT SOURCE CONTAINED IN THIS LUMINAIRE SHALL ONLY BE REPLACED BY THE

MANUFACTURER OR HIS SERVICE AGENT OR A SIMILAR QUALIFIED PERSON

- THE EXTERNAL FLEXIBLE CABLE OR CORD OF THIS LUMINAIRE CANNOT BE REPLACED; IF THE CORD IS

DAMAGED, THE LUMINAIRE SHALL BE DESTROYED.

- DO NOT OPERATE THE PRODUCT WITH A DAMAGED LENS; THE DAMAGED LENS SHOULD BE REPLACED BY

THE SERVICE AGENT.

- THE DRIVER CAN'T BE REPLACED.

- THE TERMINAL IS RATED VOLTAGE IS 300V,RATED CURRENT IS 3A,THE WRING IS NOT LESS THAN 3 X 1.0MM².

- WHEN PRODUCTS ARE INSTALLED IN HIGH WIND ENVIRONMENTS, APPROPRIATE INSTALLATION/FASTENING

METHODS MUST BE APPLIED SO THAT THE PRODUCT MOUNTING POINTS ARE NOT DAMAGED DUE TO

VIBRATION,MOVEMENT OR CORROSION.

- GOOD PRACTICE DOES NOT RECOMMEND CONTINUOUS USE WITHOUT APPROPRIATE SWITCHING CYCLES.

RÉF.

COB-BEL-135-VG

Installation of LED High Bay

1. Disconnect mains supply before installation or

removing cover.

LED High Bay Installation Guide

Size

300x270mm

135W

IP65

AC220-240V

2. Use a screwdriver to fix the reflector to the luminaire with screws.

50Hz