CeoTronics CT-DECT Base 사용 설명서 - 페이지 9
{카테고리_이름} CeoTronics CT-DECT Base에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. CeoTronics CT-DECT Base 20 페이지. Headset for wireless duplex communication
CeoTronics CT-DECT Base에 대해서도 마찬가지입니다: 사용 설명서 (20 페이지), 사용 설명서 (14 페이지), 사용 설명서 (14 페이지), 사용 설명서 (20 페이지)
페이지 인쇄2.
Description
2.1
General
The headset is a transmitter/receiver for wireless duplex communication between a max. of three
communication parties over short distances. The range depends on the local circumstances. Up to two
standard headsets are allocated to a base headset. Channel selection is effected automatically by the
headsets. High protection against eavesdropping and interferences is ensured.
The headset protects against harmful ambient noise and allows communication in noisy environments.
The headset microphone is noise-compensating and is equipped with a windshield and a flexible
gooseneck.
The minimum version of the system comprises one base headset and one standard headset. A second
standard headset can be operated in conjunction with the base headset.
Base and standard headsets are marked by an imprint on the left headset muff, as follows:
– CT-DECT Base
– CT-DECT Standard
2.2
Usage within a CT-DECT system
In a CT-DECT system instead of the base headset for example the base station »CT-DECT
Conference« or the table top device »CT-DECT Station« is used. Notice the special CeoTronics
operating instructions for these devices.
2.3
Usage within a CT-GateCom system
In a CT-GateCom system instead of the base headset a CT-GateCom Compact is used that usually
resides in a weatherproof carrying bag. Notice the special CeoTronics operating instructions for the CT-
GateCom Compact.
2.4
Power supply and operating time
Power for the headset is supplied by a 3.6 V/2300 mAh NiMH rechargeable battery in the right headset
muff. With fully charged 3.6 V/2300 mAh NiMH battery the operating time for continuous operation is
approx. 20 hours.
2.5
Audio signals used
Two different tones are used for signalling the operating status. The tone for the indication of a positive
operating status has a higher frequency than the tone for the indication of a negative operating status.
Signalling of the various operating status is effected by a varying number of consecutive high tones or
low tones.
Positive acknowledgement tone
All positive operating status are indicated by a high tone.
Negative acknowledgement tone and error tone
All negative operating status and error status are indicated by a low tone.
2.6
Sidetone
The sidetone while speaking is audible in the headsets only after connection setup between the
headsets. Due to this a control is always available as to whether a connection is active or not.
In the case of the CT-GateCom system there isn't a sidetone audible in the headsets.
CT-GateCom Base
CT-GateCom Standard
9