IKEA IH3402YS0 설치 지침 및 사용 및 관리 매뉴얼 - 페이지 10
{카테고리_이름} IKEA IH3402YS0에 대한 설치 지침 및 사용 및 관리 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. IKEA IH3402YS0 40 페이지. 30" (76.2 cm) range hood
페이지 인쇄2. Use UL listed wire connectors
and connect white wires (A)
together.
3. Use UL listed wire connectors
and connect black wires (B)
together.
Fire Hazard
Electrically ground the blower.
Use copper wire.
Connect ground wire to green ground screw in
terminal
box.
Failure to do so can result in death, fire, or
electrical
shock.
4. Connect green (or bare) ground wire from power supply to
green ground screw in terminal box and securely tighten.
5. Install terminal box cover.
6. Reconnect power.
1. Install the 75W (max.) Incandescent
light bulb. See
"Replacing the Incandescent
Light Bulb" in the "Range Hood
Care" section.
2. Replace grease filter if removed. See the "Range Hood Care"
section.
3. Check the operation of the range hood fan and light. See
"Range Hood Use" section.
If range hood does not operate, check to see whether a
circuit breaker has tripped or a household fuse has blown.
Disconnect
power and check wiring connections.
NOTE: To get the most efficient use from your new range hood,
read the "Range Hood Use" section.
RANGE HOOD USE
The range hood is designed to remove smoke, cooking vapors
and odors from the cooktop area. For best results, start the hood
before cooking and allow it to operate several minutes after the
cooking is complete to clear all smoke and odors from the
kitchen.
The hood controls are located on the top of the range hood.
A
B
C
A. Incandescent
light housing and cover
B. Filter retainer
C. Grease filter
cu-_w-s_ss blooc
Colqt_}
s
Off
On{__Off
Low@
High
A
B
A. On/Off light switch
B. Fan speed switch
Operating
the light
Push the light switch to the right to turn the light Off. Push the
light switch to the left to the turn the light On.
Operating
the fan
Push the fan switch to the left for Low speed. Push the fan switch
to the right for High speed. Push the fan switch to the middle for
Off.
RANGE HOOD CARE
IMPORTANT: Clean the hood and grease filters frequently
according to the following instructions.
Replace grease filter
before operating hood.
Exterior
Surfaces:
IMPORTANT:
Do not use soap-filled scouring pads, abrasive
cleaners, Cooktop Polishing Creme, steel wool, gritty washcloths
or paper towels.
Cleaning
Method:
•
Rub in direction of grain to avoid scratching
or damaging the
surface.
•
Liquid detergent or all-purpose
cleaner:
Rinse with clean water and dry with soft, lint-free cloth.
•
Glass cleaner to remove fingerprints.
Metal Grease Filter
1. Remove screw from the grease filter retainer.
2. Turn the grease filter retainer to release filter.
A. Filter retainer
3. Wash metal filters as needed in dishwasher or hot detergent
solution.
4. Reinstall the filter by placing the back edge in the channel at
rear of hood. Push filter into place, turn the filter retainer to
secure filter to range hood.
5. Replace screw in the grease filter retainer.
10