IKEA IHW53UC0FS1 설치 지침 매뉴얼 - 페이지 9

{카테고리_이름} IKEA IHW53UC0FS1에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. IKEA IHW53UC0FS1 30 페이지. 30" (76.2 cm) wall-mount canopy range hood

Install Range Hood

NOTE: Remove protective film from range hood and metal filters.

1. Using 2 or more people, hang range hood on 2 mounting

screws through the mounting slots on back of hood.

A. Mounting screws

B. Mounting slots

C. Lower mounting screws

2. Remove the grease filter. See "Range Hood Care" section.

3. Level the range hood and tighten upper mounting screws.

4. Install (2) 5 x 45 mm lower mounting screws and tighten.

Use the optional wall anchors if needed.

1. Install transition on top of hood (if removed for shipping)

with (2) 3.5 x 9.5 mm (Phillips) sheet metal screws.

A. Vent transition

B. 3.5 x 9.5 mm screw

For vented installations only:

1. Fit vent system over transition piece.

2. Seal connection with clamps.

3. Check that back draft dampers work properly.

For non-vented (recirculating) installation only:

1. Assemble the air deflector with the duct cover bracket with

2. Measure from the bottom of the air deflector to the bottom

3. Cut the duct to the measured size "X."

4. Remove the air deflector.

5. Slide the duct onto the bottom of the air deflector.

6. Place the assembled air deflector and duct over

7. Reassemble the air deflector to the duct cover bracket

8. Seal connections with vent clamps.

2 assembly screws.

A. Vent cover bracket

B. 2.9 x 6.5 mm screws

C. Deflector

of the hood outlet.

A. Air deflector

B. Vent clamp

C. X = length to cut vent duct

D. Vent duct

E. Exhaust outlet

the exhaust outlet from the hood.

with the 2 assembly screws.