KitchenAid KHIS 7720 사용 설명서 지침 - 페이지 8
{카테고리_이름} KitchenAid KHIS 7720에 대한 사용 설명서 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. KitchenAid KHIS 7720 20 페이지.
KitchenAid KHIS 7720에 대해서도 마찬가지입니다: 사용 설명서 지침 (20 페이지)
페이지 인쇄
Before use
IMPORTANT: the cooking zones will not switch on if pots and pans are not of the
correct dimensions. Only use pots bearing the symbol "INDUCTION SYSTEM"
(See figure opposite). Before switching the hob on, position the pot on the desired
cooking zone.
Using existing pots and pans
Use a magnet to check whether pots or pans are suitable for use on the induction hob: pots are unsuitable
if they cannot be magnetically detected.
- Ensure pots have a smooth bottom, otherwise they may scratch the hob's glass ceramic surface. Check
dishes.
- Never place hot pots or pans on the hob's control panel. This could result in damage.
Recommended pan base diameters
XL
Ø 30 cm
L
Ø 24 cm
M
Ø 18 cm
IMPORTANT: Refer to the "SENSOR" section for correct pan base diameters for cooking zones with
SENSOR function.
Installation
After unpacking the hob, check that there has been no damage during
transport. If in doubt, contact the dealer or After-sales Service.
PREPARING THE HOUSING UNIT
WARNING
- Install a separator panel under the hob.
- The lower part of the product must not be accessible after
installation.
- If there is an oven beneath the hob, do not install the separator
panel.
• For the distance between the underside of the appliance and the
separator panel below, observe the dimensions given in the diagram.
• Do not obstruct the minimum required clearance between the hob and
the top of the unit to ensure the correct operation of the product.
• Cut the worktop to fit before installing the hob and carefully remove
any shavings or sawdust.
OK
Ø 14 cm
30 cm
Ø 17 cm
24 cm
Ø 14 cm
18 cm
NO
XL
Ø 28 cm
L
Ø 21 cm
S
Ø 14,5 cm
8
Ø 18 cm
28 cm
Ø 15 cm
21 cm
Ø 11 cm
14,5 cm
min 20
min 5