KitchenAid KICU540BSS0 설치 지침 매뉴얼 - 페이지 5
{카테고리_이름} KitchenAid KICU540BSS0에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. KitchenAid KICU540BSS0 12 페이지. Electric induction cooktop
페이지 인쇄Electrical Shock Hazard
Disconnect power before servicing.
Use 8 gauge copper wire.
Electrically ground cooktop.
Failure to follow these instructions can result in death,
fire, or electrical shock.
This cooktop is manufactured
with a frame-connected,
green (or
bare) ground wire.
1. Disconnect
power.
2. Remove junction box cover if it is present.
3. Connect the flexible cable conduit from the cooktop to the
junction box using a UL listed or CSA approved conduit
connector.
A. UL listed or CSA approved
conduit connector
4. Tighten screws on conduit connector if present.
5. See "Electrical Connection
Options Chart" to complete
installation for your type of electrical connection.
Electrical
Connection
Options Chart
If Your Home Has:
Go to Section:
4-wire
4-Wire Cable from Power Supply
4-Wire Cable from Power Supply to 3-Wire Cable from
Cooktop
IMPORTANT: Use the 4-wire cable from power supply where
local codes do not permit connecting the frame-ground
conductor to the neutral (white) junction box wire.
I
A
C
D
E
A. 4-wire cable from power
supply
B. Red wire from power supply
C. White wire from cooktop cable
D. Green (or bare) ground wires
from cooktop
cable
E. 3-wire cable from cooktop
'_
.........................................
F
F. Junction box
G. White wire from power supply
H. UL listed wire connector
I. Black wires
J. UL listed or CSA approved conduit
connector with wire bushing
1. Connect the red wire (B) (in the junction box) to the white wire
(C) from the cooktop cable using a UL listed wire connector.
2. Connect the green (or bare) ground wire (D) from the cooktop
cable to the green (or bare) ground wire (in the junction box)
using a UL listed wire connector.
3. Put a UL listed wire connector on the end of the white
wire (G).
NOTE: Do not connect the green (or bare) ground wire to the
neutral (white) wire in the junction box.
4. Connect the 2 black wires (I) together using a UL listed wire
connector.
5. Install junction box cover.
3-wire
3-Wire Cable from Power Supply
I//2"