Avantco 178APT48HC 사용자 설명서 - 페이지 4

{카테고리_이름} Avantco 178APT48HC에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Avantco 178APT48HC 13 페이지. Commercial refrigerator

User Manual

Electrical

•

Please ensure that the required voltage of the compressor is being supplied at all times. Low or high

voltage can detrimentally affect the refrigeration unit.

• All units should be plugged into a grounded and properly-sized electrical outlet with appropriate

overcurrent protection. Please refer to the electrical requirements on the nameplate.

• Please make sure that your unit has its own dedicated outlet.

• Do not use an extension cord.

Temperature Controls

• Refrigerant LED - Compressor is on

• Fan LED - Fan is on

• Defrost LED - Defrost cycle is running

Functions

Your new refrigerator or freezer is already factory-set to run at optimum temperatures for food

safety and should require no adjustments.

Refrigerators are set to cycle between a minimum temperature of 33 degrees Fahrenheit and a

maximum temperature of 40 degrees Fahrenheit.

Adjusting the temperature changes the minimum temperature your unit will run at. Your unit will not

run constantly at this setting. To change it, follow these instructions:

Digital Control Units

• Hold "SET" for 1 sec. The display will flash the current minimum temperature.

• Use the arrow buttons to adjust the minimum temperature you want it to run at.

• Press "SET" again to save your settings

Always remember to calculate the differential if you change the minimum temperature setting. The

cabinet temperature will fluctuate up to +7 degrees over your set minimum temperature as the

compressor runs and shuts off. Setting the temperature too high will result in unsafe maximum

temperatures.

- 4 -