KitchenAid Pro Line KGCP463K 설치 지침 매뉴얼 - 페이지 8
{카테고리_이름} KitchenAid Pro Line KGCP463K에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. KitchenAid Pro Line KGCP463K 12 페이지. Pro line series 36" and 48" gas cooktop, for residential use only
KitchenAid Pro Line KGCP463K에 대해서도 마찬가지입니다: 치수 매뉴얼 (1 페이지)
페이지 인쇄
InstaJling the griJie
or griddHe.
Grille installation:
Go to Step 15.
Griddle installation:
The griddle is
factory installed. To complete the
installation, go to Step 16.
E Installing
the grille:
A,
Lift the log burner up out of the bay
and set aside.
D,
Reinstall the log burner. Make sure
burner's rear flange is seated in slot.
E,
Plug power supply cord into
grounded outlet.
F,
Check the surface burner and grille
flames. Before completing
the gdtle
installation,
go to "Check the operation
of the surface burners, grille and griddle"
on Page 9.
s_ot for
tg tab
6
R Completing
the griddle
hstaHation:
griddle
drip tray
A,
Place drip tray in the well at the
front of the griddle. Slide tray forward until
it stops.
B,
Refer to the Use and Care Guide
that came with your Cooktop for
instructions on cleaning and seasoning
the griddle before using.
tray
B,
Place drip tray on bottom of grille
bay and slide the tray forward so that it is
located side-to-side and against the
locating feet of the rear spill guard.
_ocating
. tab
G,
Install the wave tray into the
grille/griddle bay. The tab in the left rear
corner of the bay must fit through the slot
in the left rear corner of the wave tray.
wave
wave
tray
_
plate
\
C,
Plug power supply cord into
grounded outlet.
D,
Check the surface burner and
griddle flames. Go to "Check the
operation of the surface burners, grille
and griddle" on Page 9.
insert feet
into s_ots
C,
Insert the front spill guard feet into
the slots in the rear spill guard as shown.
The rear flange will rest on the burner box.
8
H,
Place the wave plate on the wave
tray as shown. The wave plate must be
centered
on the wave tray.
_, Install the grille grate.