IKEA LUFTIG 사용자 설명서 - 페이지 4

{카테고리_이름} IKEA LUFTIG에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. IKEA LUFTIG 12 페이지. Exhaust hood
IKEA LUFTIG에 대해서도 마찬가지입니다: 사용자 설명서 (12 페이지), 사용 설명서 (28 페이지), 설치 지침 및 사용 및 관리 매뉴얼 (44 페이지), 매뉴얼 (16 페이지), 설치 매뉴얼 (24 페이지), 사용 설명서 (40 페이지), 매뉴얼 (16 페이지), 사용자 설명서 (28 페이지), 어셈블리 (11 페이지), 설치 지침 (4 페이지), 매뉴얼 (24 페이지)

IKEA LUFTIG 사용자 설명서
ENGLISH
Contents

Safety information

For your safety and correct operation of the
appliance, read this manual carefully before
installation and use. Always keep these
instructions with the appliance even if you move
or sell it. Users must fully know the operation and
safety features of the appliance.
Recommendations and suggestions
• This appliance is intended to be used in
household and similar applications such as:
Farm houses.
By clients in serviced apartments, holiday
apartments and other residential type
environments.
• The manufacturer will not be held liable for
any damages resulting from incorrect or
improper installation.
• The minimum safety distance between the
cooker top and the extractor hood is: for elec-
trical hob 500mm and for gas hob 650mm.
• If the instructions for installation for the gas
hob specify a greater distance, this must be
respected.
• Check that the mains voltage corresponds to
that indicated on the rating plate fixed to the
inside of the hood.
• For Class I appliances, check that the do-
mestic power supply guarantees adequate
earthing.
• Connect the extractor to the exhaust flue
through a pipe of minimum diameter 120
mm. The route of the flue must be as short as
possible.
• Do not connect the extractor hood to exhaust
ducts carrying combustion fumes (boilers,
fireplaces, etc.).
• If the extractor is used in conjunction with non-
electrical appliances (e.g. gas burning appli-
4
5
6
ances), a sufficient degree of aeration must be
guaranteed in the room in order to prevent
the backflow of exhaust gas. When the cooker
hood is used in conjunction with appliances
supplied with energy other than electric, the
negative pressure in the room must not exceed
0,04 mbar to prevent fumes being drawn back
into the room by the cooker hood.
• WARNING: Failure to install the screws or
fixing device in accordance with these instruc-
tions may result in electrical hazards.
• If the supply cord is damaged, it must be
replaced from the manufacturer or its service
agent.
• Connect the plug to a socket complying with
current regulations, located in an accessible
place.
• Connect the hood to the power net by using
a bipolar switch having a contact gap of at
least 3 mm.
• With regards to the technical and safety
measures to be adopted for fume discharg-
ing it is importat to closely follow the regula-
tions provided by the local authorities.
• WARNING: Before installing the Hood,
remove the protective films (white and trans-
parent).
Use
• The extractor hood has been designed ex-
clusively for domestic use to eliminate kitchen
smells.
• Never use the hood for purposes other than
for which it has been designed.
• Never leave high naked flames under the
hood when it is in operation.
• Adjust the flame intensity to direct it onto the
bottom of the pan only, making sure that it
4
7
7
8
8