KitchenAid Recreational Vehicle Two-Sealed-Burner Gas Cooktop 설치 지침 매뉴얼 - 페이지 7
{카테고리_이름} KitchenAid Recreational Vehicle Two-Sealed-Burner Gas Cooktop에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. KitchenAid Recreational Vehicle Two-Sealed-Burner Gas Cooktop 8 페이지.
페이지 인쇄318" nipple
flexible
connector
3/8" nipple
\
manual shutoff
valve
piessure
regulator
-
All connections
must
be wrench-tightened.
ml
Assemble the flexible connector from
the gas supply pipe to the pressure
.
regulator in order: Manual shutoff
valve, 3/8" nipple, 3/8" adapter, flexible
connector, 3/8" adapter, and 3/8" nipple.
Use pipe-joint compound made for
use with L.P. gas to seal all gas
connections.
If flexible connectors
are used, be certain connectors are not kinked.
shutoff
valve
Open the shutoff valve in the gas
supply line. Wait a few minutes for
gas to move through the gas line.
1131
Use a brush and liquid detergent to
test all gas connections
for leaks.
'
Bubbles around connections
will
indicate a leak.
If a leak appears, shut off gas valve controls and
adjust connections.
Then check connections
again. NEVER TEST FOR GAS LEAKS WITH A
MATCH OR OTHER FLAME. Clean all detergent
solution from cooktop.
/14.1
Plug the power supply
cord into the
grounded outlet.
I
Place burner
grates over
burners and caps.
Install control knobs on valve
stems.
Electronic Ignition System -
initial lighting
Cooktop burners use electronic ignitors in place
of standing pilots. When the cooktop control knob
is turned to the "HI" position, the system creates
a spark to light the burner. This sparking
continues until the burner ignites.
each control knob to "HI"
fit
LO
position. The flame should
6
light within 4 seconds.
w
2
If the burners do not light
5
3
4
properly, turn the control
knob to the "OFF" position. Check that the
burner cap is plugged in and that the circuit
breaker or fuse has not blown. Check that the
shutoff valve is in the "ON" position. Check
operation again. If burner does not light at this
point, contact your KitchenAid
dealer for
assistance.
117.1
Check each cooktop burner
for proper flame. The small
inner cone should have a
very distinct blue flame approximately
l/2" long. The outer cone is not as
distinct as the inner cone.
1181
Push in and turn each
. control knob to the "LO" (or simmer)
setting. The "LO" setting of each
burner has been factory set to the lowest setting
available to provide reliable reignition of the
burner. If it does not stay lit on the "LO" setting,
contact your KitchenAid dealer for assistance.
To get the most efficient
use from
your new cooktop,
read your
KitchenAid
Use and Care Guide.
Keep Ins talla tion Instructions
and
Guide close to cooktop
for easy
reference.
7