KitchenAid WCG Series 프로판 전환 지침 - 페이지 6

{카테고리_이름} KitchenAid WCG Series에 대한 프로판 전환 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. KitchenAid WCG Series 20 페이지. Lp gas

페이지 인쇄

9. To Convert Torch Burner

■

Remove the spring that is shown in the following

illustration (C).

■

Use 7.0 mm wrench to loosen and remove the inner

orifice spud (A) and the outer orifice spud (B).

■

Set gas orifice spuds aside.

■

Replace with correct LP gas orifice spud. See the LP gas

orifice spud charts.

■

Return the spring to its original location.

A. Inner orifice spud

B. Outer orifice spud

C. Spring

IMPORTANT: Place Natural gas orifice spuds in plastic parts

bag for future use and keep with package containing

literature.

10. Replace sheet of insulation.

11. Replace burner bases and burner caps.

The igniter electrode is ceramic and could break during

conversion. Be sure that the electrode comes through the

hole in the burner smoothly while you are replacing the burner

base.

A. Burner cap

B. Electrode

C. Burner base

12. Open shutoff valve in the gas supply line. The valve is open

when the handle is parallel to the gas pipe.

13. Plug in cooktop or reconnect power.

REMEMBER: Once you have completed converting all of the

cooktop burners, test the cooktop for leaks by brushing on

an approved noncorrosive leak-detection solution. If bubbles

appear, a leak is indicated. Correct any leaks found.

14. To adjust single and dual valves, see the "Flame Height

Adjustment" section.

Convert from LP Gas to Natural Gas

1. Turn manual shutoff valve to the closed position.

A. To cooktop

B. Shutoff valve (closed position)

C.Gas supply line

2. Unplug cooktop or disconnect power.

To Convert Gas Pressure Regulator

A. Access cap

B. Rear of cooktop

C. Gas pressure regulator

D. Gas flow

3. Determine the type of regulator you have:

Style 1: The cap has a slot and "LP" printed on it.

Remove access cap by using a flat-blade screwdriver or coin,

turning the access cap counterclockwise.

The gas pressure regulator has 2 settings that are stamped

on either side of the cap. Turn the cap and reinstall into

regulator with the stamp "NAT" visible from the outside of the

regulator.

Style 2: The cap does not have a slot and requires a wrench

to be removed.

Remove the access cap by using a wrench, turning the

access cap counterclockwise.

NAT