IKEA W10258591A 설치 지침 및 사용 및 관리 매뉴얼 - 페이지 4
{카테고리_이름} IKEA W10258591A에 대한 설치 지침 및 사용 및 관리 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. IKEA W10258591A 24 페이지. 30" (76.2 cm) vented range hood
페이지 인쇄
INSTALLATION REQUIREMENTS
Gather the required tools and parts before starting installation.
Read and follow the instructions
provided with any tools listed
here.
Tools needed
•
Level
•
Drill
•
1 V4"drill bit
•
1/8"(3 ram) drill bit for pilot holes
•
Pencil
•
Pliers
•
Wire stripper or utility knife
•
Tape measure or ruler
•
Caulking gun and weatherproof
caulking compound
•
Phillips screwdriver
•
Saber or keyhole saw
•
Vent clamps
•
Metal snips
•
Compass or 7" (17.8 cm) circle template
Parts supplied
Check that all parts are included.
•
Literature package (1)
•
Hardware package (1)
•
7" (17.8 cm) round damper
Parts needed
•
UL listed or CSA approved 1/2"(12.5 mm) strain relief
•
75-watt max incandescent
light bulb
•
Power supply cable
•
7" (17.8 cm) round metal venting
For cabinets
with recessed
bottoms:
•
2 - 2" (5.1 cm) wide filler strips. Length and thickness
determined
by recess dimensions.
•
4 - flat-head wood screws or machine screws with washers
and nuts to attach filler strips.
IMPORTANT." Observe all governing codes and ordinances.
•
It is the installer's responsibility
to comply with installation
clearances specified on the model/serial rating plate. The
model/serial
rating plate is located inside the range hood on
the rear wall.
•
Range hood location should be away from strong draft areas,
such as windows, doors and strong heating vents.
•
Cabinet opening dimensions that are shown must be used.
Given dimensions provide minimum clearance. Consult the
cooktop/range
manufacturer
installation instructions
before
making any cutouts.
•
Grounded electrical outlet is required. See "Electrical
Requirements"
section.
•
The range hood is factory set for venting through the roof or
wall.
•
All openings in ceiling and wall where range hood will be
installed must be sealed.
For Mobile Home Installations
The installation of this range hood must conform to the
Manufactured
Home Construction
Safety Standards, Title 24
CFR, Part 328 (formerly the Federal Standard for Mobile Home
Construction
and Safety, Title 24, HUD, Part 280) or when such
standard is not applicable, the standard for Manufactured
Home
Installation 1982 (Manufactured
Home Sites, Communities and
Setups) ANSI A225.1/NFPA 501A*, or latest edition, or with local
codes.
Product Dimensions
29 7/8" _
12"
(75.9 crn)
(30.5 cm)
4
(15.2 cm)
7W' _ii
i
(19.1 cm)
:nockouts
Centerline