Avantco 178UBB2472GS 사용자 설명서 - 페이지 5

{카테고리_이름} Avantco 178UBB2472GS에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Avantco 178UBB2472GS 6 페이지. Back bar refrigerator

Cleaning the Interior of Unit

• When cleaning the cabinet interior, use a solvent of warm water and mild soap.

• Do not use steel wool, caustic soap, abrasive cleaners, or bleach that may damage the interior finish.

• Wash door gaskets on a regular basis, preferably weekly. Simply remove the door gasket from the

frame of the door, soak it in warm water and soap for thirty (30) minutes, then dry with soft cloth

and replace.

• Check door gaskets for proper seal after they are replaced.

• Periodically remove the shelves and shelf brackets from the unit, and clean them with a mild soap

and warm water.

Trouble Shooting

Compressor is Not Running

Fuse blown or circuit breaker tripped.

Power cord unplugged.

Thermostat set too high.

Cabinet in defrost cycle.

Cabinet Temperature is too Warm

Thermostat is set too high.

Airflow is blocked.

Low refrigerant levels.

Door is slightly ajar.

Interior Light is Not Working

Poor switch connection.

Bulb is not connected.

Bulb has burned out.

Condensation is Collecting on the Cabinet and/or Floor

Gasket is not sealing properly.

User Manual

Replace fuse or reset circuit breaker.

Plug in power cord

Set thermostat to lower temperature.

Wait for defrost cycle to finish.

Set thermostat to lower temperature.

Re-arrange products to allow for proper air flow.

Make sure there is at least four inches of clearance

from the fan.

Contact a service technician to check refrigerant levels.

Make sure door is completely closed.

Turn off light switch and turn it back on.

Make sure the bulb is correctly inserted in the socket.

Replace the bulb.

Clean, repair, or replace the gasket as necessary.

- 5 -