Avantco 178UBB378S 사용자 설명서 - 페이지 5

{카테고리_이름} Avantco 178UBB378S에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Avantco 178UBB378S 11 페이지. Back bar refrigerator
Avantco 178UBB378S에 대해서도 마찬가지입니다: 사용자 설명서 (7 페이지)

페이지 인쇄

Installation

This unit is intended for use in a temperature-controlled environment less than 75 degrees

Fahrenheit and 60% relative humidity. Malfunction due to improper conditions is not covered

under warranty.

IMPORTANT –

Please Read Before Installation:

•

If the shelf has a raised lip, the lip needs to be installed facing up towards the rear of the cabinet to

promote proper air flow. Failure to install the shelves properly is considered user-error and is not

covered by warranty.

•

If the unit has recently been transported on its side, please let the unit stand still for a minimum of

24 hours before plugging it in.

•

Make sure that the unit has reached the desired temperature before loading the unit with products.

This unit is meant for keeping cold products cold, not chilling warm products.

•

Make sure that there is proper ventilation around the unit in the area where it will operate.

•

Make sure all accessories are installed (i.e., shelves, shelf clips, casters) before plugging the unit in.

•

Do not attempt to remove or repair any component of the unit. Consult an authorized service

technician for servicing/repair.

•

Do not hang on doors or sit inside the unit.

•

Do not store flammable, explosive, or corrosive liquids or gas in or near the cooler.

•

Please read through the manual in its entirety.

•

This unit is designed to perform in a temperature-controlled environment at 60% relative humidity.

The unit should be located away from doors, air ducts, and fans that could disrupt airflow and

negatively impact performance.

Cabinet Location Guidelines

•

Install the unit on strong and leveled surfaces.

- If the surface is uneven, the unit may be noisy.

- The unit may malfunction if the surface is uneven.

•

Install the unit in an indoor, well-ventilated area.

- For best performance, please maintain clearance of 4" on the back of the unit.

- Do not use outdoors. For indoor use only.

- Avoid direct sunlight.

•

Avoid installation in a high humidity and/or dusty area.

- Humidity above 60% can cause the unit to rust, collect condensation, and may decrease efficiency.

- Dust collected on the condenser coil will cause the unit to malfunction.

- Malfunctions due to temperatures above 75 degrees Fahrenheit, humidity above 60%,

or improperly maintained condenser coil will void the warranty.

•

Select a location away from heat and moisture-generating equipment.

- Ambient temperatures above 75 degrees Fahrenheit may cause the compressor to malfunction.

- Malfunctions due to ambient temperatures above 75 degrees Fahrenheit will void the warranty.

- Do not install the unit inside a closet or alcove.

User Manual

Back Bar Refrigerators