Avantco 178UBB48GHC 사용자 설명서 - 페이지 6

{카테고리_이름} Avantco 178UBB48GHC에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Avantco 178UBB48GHC 7 페이지. Back bar refrigerator
Avantco 178UBB48GHC에 대해서도 마찬가지입니다: 사용자 설명서 (7 페이지), 사용자 설명서 (11 페이지)

Avantco 178UBB48GHC 사용자 설명서
User Manual

Cleaning the Interior of the Unit

• When cleaning the cabinet interio, use a solvent of warm water and mild soap.
• Do not use steel wool, caustic soap, abrasive cleaners, or bleach that may damage the interior finish.
• Wash door gaskets on a regular basis, preferably weekly. Remove the door gasket from the frame of
the door, soak it in warm water and soap for (30) minutes, then dry with a soft cloth and replace.
• Check door gaskets for proper seal after they are replaced.
• Periodically remove the shelves and shelf brackets from the unit, and clean them with a mild soap
and warm water.
Trouble Shooting
Compressor is Not Running
Fuse blown or circuit breaker tripped.
Power cord unplugged.
Thermostat set too high.
Cabinet in defrost cycle.
Cabinet Temperature is too Warm
Thermostat is set too high.
Airflow is blocked.
Excessive amount of warm product placed in
cabinet.
Fuse blown or circuit breaker tripped.
Low refrigerant levels.
Prolonged door opening or door ajar.
Interior Light is Not Working
Poor switch connection.
Bulb is not connected.
Bulb has burned out.
Condensation is Collecting on the Cabinet and/or Floor
Gasket is not sealing properly.
Replace fuse or reset circuit breaker.
Plug in power cord
Set thermostat to lower temperature.
Wait for defrost cycle to finish.
Set thermostat to lower temperature.
Re-arrange products to allow for proper air flow.
Make sure there is at least four inches of clearance
from the evaporator.
Allow adequate time for product to cool down.
Replace fuse or reset circuit breaker.
Clean the condenser coil.
Ensure doors are closed when not in use.
Avoid opening doors for long periods of time.
Turn of flight switch and turn it back on.
Make sure the bulb is correctly inserted in the
socket.
Replace the bulb.
Clean, repair, or replace the gasket as necessary.
- 6 -