Avantco 178UBB48GHCS 사용자 설명서 - 페이지 5
{카테고리_이름} Avantco 178UBB48GHCS에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Avantco 178UBB48GHCS 11 페이지. Back bar refrigerator
Avantco 178UBB48GHCS에 대해서도 마찬가지입니다: 사용자 설명서 (7 페이지), 사용자 설명서 (7 페이지)
페이지 인쇄
Installation
This unit is intended for use in a temperature-controlled environment less than 75 degrees
Fahrenheit and 60% relative humidity. Malfunction due to improper conditions is not covered
under warranty.
IMPORTANT –
Please Read Before Installation:
•
If the shelf has a raised lip, the lip needs to be installed facing up towards the rear of the cabinet to
promote proper air flow. Failure to install the shelves properly is considered user-error and is not
covered by warranty.
•
If the unit has recently been transported on its side, please let the unit stand still for a minimum of
24 hours before plugging it in.
•
Make sure that the unit has reached the desired temperature before loading the unit with products.
This unit is meant for keeping cold products cold, not chilling warm products.
•
Make sure that there is proper ventilation around the unit in the area where it will operate.
•
Make sure all accessories are installed (i.e., shelves, shelf clips, casters) before plugging the unit in.
•
Do not attempt to remove or repair any component of the unit. Consult an authorized service
technician for servicing/repair.
•
Do not hang on doors or sit inside the unit.
•
Do not store flammable, explosive, or corrosive liquids or gas in or near the cooler.
•
Please read through the manual in its entirety.
•
This unit is designed to perform in a temperature-controlled environment at 60% relative humidity.
The unit should be located away from doors, air ducts, and fans that could disrupt airflow and
negatively impact performance.
Cabinet Location Guidelines
•
Install the unit on strong and leveled surfaces.
- If the surface is uneven, the unit may be noisy.
- The unit may malfunction if the surface is uneven.
•
Install the unit in an indoor, well-ventilated area.
- For best performance, please maintain clearance of 4" on the back of the unit.
- Do not use outdoors. For indoor use only.
- Avoid direct sunlight.
•
Avoid installation in a high humidity and/or dusty area.
- Humidity above 60% can cause the unit to rust, collect condensation, and may decrease efficiency.
- Dust collected on the condenser coil will cause the unit to malfunction.
- Malfunctions due to temperatures above 75 degrees Fahrenheit, humidity above 60%,
or improperly maintained condenser coil will void the warranty.
•
Select a location away from heat and moisture-generating equipment.
- Ambient temperatures above 75 degrees Fahrenheit may cause the compressor to malfunction.
- Malfunctions due to ambient temperatures above 75 degrees Fahrenheit will void the warranty.
- Do not install the unit inside a closet or alcove.
User Manual
Back Bar Refrigerators
www.AvantcoRefrigeration.com
5