Ganz digimaster DR-4FX1 설치 매뉴얼 - 페이지 9

{카테고리_이름} Ganz digimaster DR-4FX1에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Ganz digimaster DR-4FX1 17 페이지. Digimaster series 4ch;8ch;16ch

Change the remote control ID

The remote control will be active only if the remote control ID matches with that specified on the

DVR.

If multiple DVRs are installed on one place and you have just a single remote control, use the ID

button to set the remote control ID. Only the ID-matching DVR can be controlled.

From <SYSTEM> - <CONTROL DEVICE> under the System Setup menu, set the

<REMOTE CONTROLLER ID> and press <Apply>.

Select between 00 and 99. For more details, refer to <SYSTEM SETUP>.

The remote control will be active only if the remote control ID matches with that of the

DVR's system ID.

Press the [ID] button on the remote control. The default remote control ID is 00.

Use the number buttons to provide a two-digit ID. If you want to enter 01, for instance,

enter the number 0 and 1 in sequence.

Check if the remote control ID is set properly by manipulating the remote control.

To reset the ID to 00, press and hold the [ID] button.

OVERVIEW

９