HIKVISION TURBO HD DS-2CE56H0T-ITMF 사용자 설명서 - 페이지 9
{카테고리_이름} HIKVISION TURBO HD DS-2CE56H0T-ITMF에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. HIKVISION TURBO HD DS-2CE56H0T-ITMF 17 페이지. Turbo hd bullet & dome camera
HIKVISION TURBO HD DS-2CE56H0T-ITMF에 대해서도 마찬가지입니다: 사용자 설명서 (16 페이지)
페이지 인쇄
5. Route the cables through the cable hole, or the side
opening.
6. Connect the corresponding cables, such as power
cord, and video cable.
7. Power on the camera to check whether the image
on the monitor is gotten from the optimum angle. If
not, adjust the camera according to the figure below
to get an optimum angle
0° to 75°
Figure 2-10 Type I Camera 2-Axis Adjustment
1). Loosen the tilt adjusting screw to adjust the tilt
position [0° to 75°].
2). Hold the camera to adjust the pan position [0°
to 355°].
3). Hold the camera body to adjust the rotation
position [0° to 355°].
8. Reinstall the bubble, and tighten the screws to finish
the installation.
2.4 Ceiling Mounting of Type IV Camera
Steps:
1. Align the snap joint, and then insert the screw driver
to the snap joint.
Figure 2-9 Fix the Mounting Base
Figure 2-11 Bubble Reinstallation
0° to 355°
Adjusting Screw
0° to 355°
Align the
Snap Joint