Ganz PixelMaster PRO NR16H 빠른 매뉴얼
{카테고리_이름} Ganz PixelMaster PRO NR16H에 대한 빠른 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Ganz PixelMaster PRO NR16H 4 페이지.
페이지 인쇄
Quick Guide
8CH / 16CH Full HD NVR
Rear View
Installation
CAM1-CAM8
WAN(UPLINK)
AUDIO IN
ALARM OUT
RS-485
Power Switch
Basic Layout
IP Camera
Network
DMS,
Attached
Web viewer
Storage
Mobile Viewer
(for backup)
Full HD monitor
Output for two monitors at the same time is not supported. Ether one of HDMI and VGA
output to one monitor is available.
Signal connection for POS and ATM is scheduled to be upgraded later.
Ethernet ports used for connecting the network cameras.
Network ports for connection to the internet, router or hub.
Microphone connection port.
Alarm Out port.
Communication port for connecting peripherals such as system
keyboards.
Power switch of the NVR.
Plug the power cord and turn this switch on
IP camera
External Hub
External eSATA
Storage
Microphone
Sensor
Control
Device
Speaker
POS
ATM
Access
controller
No.
AC input
RS-232C
ALARM IN
AUDIO OUT
USB
eSATA
VGA
HD MONITOR
LAN(DOWNLINK)
Connecting the camera
CAM 1-8 CH
Alarm
If the IP camera provides the alarm I/O port or Audio I/O port, you can make alarm or audio
connection. For more details, refer to the user manual of the IP camera.
Item
Description
NVR power input port. 100-240V AC, 50/60Hz
Signal connection port for POS and ATM.
Scheduled to be upgraded.
Alarm input signal port.
Port for speaker connection.
Port for connecting USB devices. (For mouse, backup device or
firmware upgrading)
Connection port for external SATA storage (HDD).
VGA video output port.
Port for connecting a full HD (1920x1080) supported monitor.
Use the HDMI cable to connect with a 1080p 60Hz monitor.
Exclusive Port dedicated to connect the NVR Hub.
Do not share with other device.
CAM 9-16 CH
IP camera
Extender Hub
(Only for 16 Channel NVR)