Green Power GNLS05T-1020H 소유자 매뉴얼 - 페이지 10

{카테고리_이름} Green Power GNLS05T-1020H에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Green Power GNLS05T-1020H 14 페이지. 5 ton log splitter

REPLACING HYDRAULIC OIL

Replace the Hydraulic oil in the log

splitter after every 150 hours of use.

Take following steps to replace it.

Make sure all moving parts stops and

the log splitter is unplugged.

Unscrew Oil Drain Bolt with Dipstick

to remove it.

Turn the log splitter on the Support

Leg side over an 4 liters capacity

container to drain the hydraulic oil off.

Turn the log splitter on the the motor

side.

Refill fresh hydraulic oil at the volume

as per the hydraulic oil capacity of a

particular model indicated in above

specifications table.

Clean the surface of Dipstick on the

Oil Drain Bolt and put it back into the

oil tank while keep the log splitter

vertically.

Make sure the level of the refilled oil

is just between 2 grooves around the

Dipstick.

Clean the Oil Drain Bolt before

thread them back. Make sure they

are tightened to avoid leakage before

place the log splitter horizontally.

Periodically check oil level to ensure

it is between 2 grooves around the

Dipstick. Upon Lower oil level, oil

refilling is required.

Following hydraulic oils or equivalent are recommend for the log splitter's hydraulic

transmission system:

SHELL Tellus 22

MOBIL DTE 11

ARAL Vitam GF 22

BP Energol HLP-HM 22