Green Power GNLS05T-1020H 소유자 매뉴얼 - 페이지 6

{카테고리_이름} Green Power GNLS05T-1020H에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Green Power GNLS05T-1020H 14 페이지. 5 ton log splitter

SET UP AND PREPARATION FOR OPERATION

1. Bolt the Support Leg to the Log Splitter, lift the log splitter by the handles at both ends

and place it on a 23.6 - 29.5in high, stable, flat and level work surface.

2. Familiarize yourself with the controls and features of this log splitter in the illustrations.

1. Log Pusher

2. Work Table

3. Wedge

4. Lift Handle

5. Support Leg

6. Log Retaining Plates

7. Switch

8. Motor

9. Pushbutton Box

10. Wheels for Minor Moving

ONLY.

11. Hydraulic Control Lever

12. Control Lever Guard

13. Bleed Screw

14. Oil Drain Bolt w/ Dipstick

Before operating the log splitter, the Bleed Screw should be loosened by some

rotations until air can go in and out of the oil tank smoothly.

Air flow thru the Bleed Screw hole should be detectable during the log splitter is

under operations.

Before moving the log splitter, make sure the Bleed Screw is tightened to avoid oil

leaking from this point.

FAILED TO LOOSEN THE BLEED SCREW WILL KEEP THE SEALED AIR IN HYDRAULIC

SYSTEM BEING COMPRESSED AFTER BEING DECOMPRESSED. SUCH CONTINUOUS

AIR COMPRESSION AND DECOMPRESSION WILL BLOW OUT THE SEALS OF THE

HYDRAULIC SYSTEM AND CAUSE PERMANT DAMAGE TO THE LOG SPLITTER.