HIKVISION TURBO HD TVI DS-2CE16D0T-IRE 사용자 설명서 - 페이지 7
{카테고리_이름} HIKVISION TURBO HD TVI DS-2CE16D0T-IRE에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. HIKVISION TURBO HD TVI DS-2CE16D0T-IRE 15 페이지. Turbo hd tvi bullet & turret camera
HIKVISION TURBO HD TVI DS-2CE16D0T-IRE에 대해서도 마찬가지입니다: 사용자 설명서 (17 페이지)
페이지 인쇄
Figure 2. 2 Secure the Camera to the Ceiling
Note:
The supplied screw package contains self-tapping
screws, and expansion bolts.
For cement wall, expansion bolts are required to fix
the camera. For wooden wall, self-tapping screws
are required.
4.
Route the cables through the cable hole (optional),
or the side opening.
5. Connect the corresponding power cord, and video
cable.
6. Power on the camera to check whether the image
on the monitor is gotten from the optimum angle.
If not, adjust the camera according to the figure
below to get an optimum angle.
Figure 2. 3 3-Axis Adjustment
1) Loosen the No.1 adjusting screw to adjust the
pan position (0° to 360°).
2) Tighten the No.1 adjusting screw.
3) Loosen the No.2 adjusting screw to adjust the
tilting position (0° to 90°).
4) Tighten the No. 2 adjusting screw.
5) Loosen the No.3 adjusting screw to adjust the
rotation position (0° to 360°).
6) Tighten the No.3 adjusting screw.
2.3
Installation of Type II Camera
Before you start:
Both wall mounting and ceiling mounting are suitable
for the bullet camera. Ceiling mounting will be taken as
an example in this section. You can take the steps of
ceiling mounting as a reference, when adopting wall
mounting.
Steps:
1. Paste the dill template to the ceiling.
2. Drill the screw holes according to the drill template,
and the cable hole (optional) on the ceiling.