HIKVISION TURBO HD TVI DS-2CE56D0T-IT1E 사용자 설명서 - 페이지 11
{카테고리_이름} HIKVISION TURBO HD TVI DS-2CE56D0T-IT1E에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. HIKVISION TURBO HD TVI DS-2CE56D0T-IT1E 17 페이지. Turbo hd tvi bullet & turret camera
HIKVISION TURBO HD TVI DS-2CE56D0T-IT1E에 대해서도 마찬가지입니다: 사용자 설명서 (15 페이지)
페이지 인쇄
2.5
Installation
Before you start:
Both wall mounting and ceiling mounting are suitable
for the turret camera. Ceiling mounting will be taken as
an example in this section. You can take steps of ceiling
mounting as the reference, when adopting the wall
mounting.
Steps:
1. Disassemble the turret camera by rotating the
camera to align the notch to the clip plate, as shown
in the Figure 2-10.
2. Pry the mounting base to remove the mounting
base from the camera body.
3. Paste the drill template (supplied) to the place
where you want to install the camera.
4. Drill the screw holes according to the drill template,
and the cable hole (optional) on the ceiling.
Note:
Drill the cable hole in the center of the drill template,
when adopting the ceiling outlet to route the cable.
5. Secure the mounting base to the ceiling with the
supplied screws.
Note:
The supplied screw package contains self-tapping
screws, and expansion bolts.
For cement wall/ceiling, expansion bolts are
required to fix the camera. For wooden
wall/ceiling, self-tapping screws are required.
6. Route the cables through the cable hole, or the side
opening.
7. Secure the camera on the mounting base.
of Type IV Camera
Figure 1-1 Disassemble the Camera
Figure 1-2 Drill Template
Expansion Bolts
Fixing Screw
Figure 1-3 Fix the Mounting Base to
the Ceiling