HIKVISION TURBO HD U1T Series 사용자 설명서 - 페이지 6
{카테고리_이름} HIKVISION TURBO HD U1T Series에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. HIKVISION TURBO HD U1T Series 15 페이지. Bullet & turret camera
HIKVISION TURBO HD U1T Series에 대해서도 마찬가지입니다: 사용자 설명서 (15 페이지)
페이지 인쇄
Type I Camera
Note:
Drill the cable hole, when adopting the ceiling outlet
to route the cable.
3. Loosen the screws on the bubble of the dome camera
to remove the bubble and the black liner.
4. Attach the back box of type I camera/base plate of
type II camera to the ceiling and secure them with
supplied screws.
Figure 2-2 Attach the Back Box/Base Plate
Note:
The supplied screw package contains self-tapping
screws, and expansion bolts.
For cement ceiling, expansion bolts are required to
fix the camera. For wooden ceiling, self-tapping
screws are required.
5. Route the cables through the cable hole, or the side
opening.
6. Align the camera with the back box/base plate, and
tighten the screws to secure the camera with the back
box/base plate.
Figure 2-3 Fix the camera to the Ceiling
7. Connect the corresponding cables, such as power cord
and video cable.
8. Power on the camera to check whether the image on
the monitor is gotten from the optimum angle. If not,
adjust the camera according to the figure below to get
an optimum angle.
Figure 2-1 The Drill Template
Type II Camera