HIKVISION TurboHD 사용자 설명서 - 페이지 6

{카테고리_이름} HIKVISION TurboHD에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. HIKVISION TurboHD 15 페이지. Hd 1080p turret & bullet camera

페이지 인쇄

Figure 2. 2 Remove the Clip Plate

4. F

x the mounting base to the ceiling with supplied

screws.

Note:

In the supplied screw package, both self-tapping



screws and expansion blots are contained.

If the wall is cement, expansion blots are required



to fix the camera. If the wall is wooden,

self-tapping screws are required.

5. Route the cables through the cable hole and

connect the corresponding cables, such as power

cable and video cable.

6. Install the main body onto the mounting base and

insert the clip plate.

7. Tighten the screw with the wrench.

Figure 2. 3 Install the Turret Camera

8. Power on the camera to check whether the image

on the monitor is gotten from the optimum angle. If

not, adjust the camera according to the figure below

to get an optimum angle.

Figure 2. 4 3-Aix Adjustment

2.2 Installation of Bullet Camera

Note:

Both wall mounting and ceiling mounting are suitable

for the bullet camera. Ceiling mounting will be taken as

an example in this section. And you can take steps of

ceiling mounting as a reference when wall mounting is

adopted.

Steps:

1. Stick the drill template on the ceiling.

2. Drill the screw holes and the cable hole (optional) in

the ceiling according to the supplied drill template.

Note:

Cable hole is required when adopting ceiling outlet to

route the cable.

Clip

Plate

Screw

0° to 360°

0° to 75°

0° to 360°

120 °

Screw

Hole