KitchenAid KDFE104DSS 사용자 지침 - 페이지 15

{카테고리_이름} KitchenAid KDFE104DSS에 대한 사용자 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. KitchenAid KDFE104DSS 20 페이지. Front control dishwasher
KitchenAid KDFE104DSS에 대해서도 마찬가지입니다: 사용자 설명서 (17 페이지)

페이지 인쇄

It is very easy to remove and maintain the filters. The chart below shows the recommended cleaning frequency.

RECOMMENDED TIME INTERVALS TO CLEAN YOUR FILTER

Number of Loads

If you wash

Per Week

before loading

1-3

Once per year

4-7

Once per year

8-12

Once per year

13-14

Once per year

*Manufacturer's recommendation: This practice will conserve the water and energy that you would have used to prepare your dishes. This

will also save you time and effort.

Very Hard Water

If you have hard water (above 15 grains), clean your filter at least

once per month. Building up of white residue on your dishwasher

indicates hard water. For tips on removing spots and stains, see

"Troubleshooting" section.

Filter Removal Instructions

1. Turn the Upper Filter

Assembly ¼ turn

counterclockwise and lift

out.

2. Grasp the Lower Filter in

the circular opening, lift

slightly, and pull forward to

remove.

3. Clean the filters as shown

below.

Cleaning Instructions

IMPORTANT: Do not use wire brush, scouring pad, etc., as they

may damage the filters.

Rinse filter under running water until most soils are removed. If you

have hard-to-remove soils or calcium deposits from hard water, a

soft brush may be required.

Cleaning

Cleaning the exterior

†® affresh is a registered trademark of Whirlpool, U.S.A.

If you scrape and rinse

before loading

Once per year

Twice per year

To remove Upper Filter Assembly

Dishwasher Care

In most cases, regular use of a soft, damp cloth or sponge and a mild detergent is all that

is necessary to keep the outside of your dishwasher looking nice and clean. If your

dishwasher has a stainless steel exterior, a stainless steel cleaner is recommended, such

®†

as affresh

Stainless Steel Cleaner Part Number W10355016.

If you only scrape

before loading*

Twice per year

Every three months

Filter Reinstallation Instructions

1. Noting the previous

illustrations, place the

Lower Filter under the

Locating Tabs in the

bottom of the dishwasher

so the round opening for

the Upper Filter Assembly

lines up with the round

opening in the bottom of

the tub.

2. Insert the Upper Filter Assembly into the circular opening in

the Lower Filter.

3. Slowly rotate the filter clockwise until it drops into place.

Continue to rotate until the filter is locked into place. If the

filter is not fully seated (still turns freely), continue to turn

the filter clockwise until it drops and locks into place.

NOTE: The Upper Filter Assembly arrow does not have to

align with the arrow in the Lower Filter as long as the filter is

locked.

IMPORTANT: To avoid damage to dishwasher, do not operate your

dishwasher without the filters properly installed. Be sure the Lower

Filter is securely in place and the Upper Filter Assembly is locked

into place. If the Upper Filter Assembly turns freely, it is not locked

into place.

If you do not scrape or rinse

before loading

Every two months

Once per month

Every two weeks

Once per week

To replace Upper Filter Assembly