KitchenAid KDFE304DSS0 사용자 지침 - 페이지 9

{카테고리_이름} KitchenAid KDFE304DSS0에 대한 사용자 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. KitchenAid KDFE304DSS0 20 페이지.

페이지 인쇄

Detergent remains in the covered section of the dispenser

Is the cycle complete?

Is the detergent lump-free? Replace detergent if necessary.

White residue on the front of the access panel

Was too much detergent used? Refer to the "Detergent

Dispenser" section.

Is the brand of detergent making excess foam? Try a different

brand to reduce foaming and eliminate buildup.

Odor in the dishwasher

Are dishes washed only every 2 or 3 days? Run a rinse cycle

once or twice a day until you have a full load.

Does the dishwasher have a new plastic smell? Run a vinegar

rinse as described in "Spotting and filming on dishes" later in

this Troubleshooting guide.

Condensation on the kitchen counter (built-in models)

Is the dishwasher aligned with the countertop? Moisture from

the vent in the dishwasher console can form on the counter.

Refer to the Installation Instructions for more information.

Dishes are not completely clean

Food soil left on the dishes

Is the dishwasher loaded correctly? Refer to the "Loading"

section in the Consumer Reference Guide.

Did you choose the cycle that describes the most difficult soil

in your dishwasher? If you have some items with heavier soils,

use a heavier cycle.

Is the water temperature too low? For best dishwashing

results, water should be 120°F (49°C) as it enters the

dishwasher. Refer to the "Performance Tips" section.

Did you use the correct amount of fresh detergent? Use

recommended dishwasher detergents only. Refer to the

"Detergent Dispenser" section. Do not use less than 1 tb

(15 g) per load. Detergent must be fresh to be effective. Store

detergent in a cool, dry area. Heavy soil and/or hard water

generally require extra detergent.

Is detergent caked in dispenser? Use fresh detergent only. Do

not allow detergent to sit for several hours in a wet dispenser.

Clean dispenser when caked detergent is present.

Is the pump or spray arm clogged by labels from bottles and

cans?

Is the home water pressure high enough for proper

dishwasher filling? Home water pressure should be 20 to

120 psi (138 to 828 kPa) for proper dishwasher fill. A booster

pump on the water supply can be added if pressure is

too low.

Are high suds slowing the wash arm? Do not use soap or

laundry detergents. Use recommended dishwasher

detergents only.

Spots and stains on dishes

Spotting and filming on dishes

Is your water hard or is there a high mineral content in your

water? Conditioning the final rinse water with a liquid rinse aid

helps eliminate spotting and filming. Keep the rinse aid

dispenser filled. Always use a high-temp option. If your water

hardness is 13 grains or above, it is strongly recommended

that you install a home water softener. If you do not wish to

drink softened water, have the softener installed onto your hot

water supply.

Is the water temperature too low? For best dishwashing

results, water should be 120°F (49°C) as it enters the

dishwasher. Refer to the "Performance Tips" section.

Did you use the correct amount of effective detergent? Use

recommended dishwasher detergents only. Refer to the

"Detergent Dispenser" section. Do not use less than 1 tb

(15 g) per load. Detergent must be fresh to be effective. Store

detergent in a cool, dry area. Heavy soil and/or hard water

generally require extra detergent.

Is the home water pressure high enough for proper

dishwasher filling? Home water pressure should be 20 to

120 psi (138 to 828 kPa) for proper dishwasher fill. A booster

pump on the water supply can be added if pressure is too low.

NOTE: To remove spots and film from dishes, try a white

vinegar rinse. This procedure is intended for occasional use

only. Vinegar is an acid, and using it too often could damage

your dishwasher.

1. Wash and rinse dishes. Use an air-dry or an energy saving

dry option. Remove all silverware or metal items.

2. Put 2 cups (500 mL) white vinegar in a glass or

dishwasher-safe measuring cup on the bottom rack.

3. Run the dishwasher through a complete washing cycle

using an air-dry or an energy saving dry option. Do not

use detergent. Vinegar will mix with the wash water.

Silica film or etching (silica film is a milky, rainbow-colored

deposit; etching is a cloudy film)

Sometimes there is a water/chemical reaction with certain

types of glassware. This is usually caused by some

combination of soft or softened water, alkaline washing

solutions, insufficient rinsing, overloading the dishwasher, and

the heat of drying. It might not be possible to prevent the

problem, except by hand washing.

To slow this process use a minimum amount of detergent but

not less than 1 tb (15 g) per load. Use a liquid rinse aid and

underload the dishwasher to allow thorough rinsing. Silica film

and etching are permanent and cannot be removed. Do not

use heated drying.

White spots on cookware with nonstick finish

Has the dishwasher detergent removed cookware seasoning?

Reseason cookware after washing in the dishwasher.

Brown stains on dishes and dishwasher interior

Does your water have high iron content? Rewash dishes using

1-3 tsp (5-15 mL) of citric acid crystals added to the covered

section of the detergent dispenser. Do not use detergent.

Follow with a Normal wash cycle with detergent. If treatment

is needed more often than every other month, the installation

of an iron removal unit is recommended.

Black or gray marks on dishes

Are aluminum items rubbing dishes during washing?

Disposable aluminum items can break down in the

dishwasher and cause marking. Hand wash these items.

Remove aluminum markings by using a mild abrasive cleaner.

Orange stains on plastic dishes or dishwasher interior

Are large amounts of tomato-based foods on dishes placed in

the dishwasher? It may be necessary to use a stain removal

product to remove stains from your dishwasher. Stains will not

affect dishwasher performance.

Dishes do not dry completely

Dishes are not dry

Did you load your dishwasher to allow proper water drainage?

Do not overload. Refer to the "Loading" section in the

Consumer Reference Guide. Use a liquid rinse aid to speed

drying.

Are the plastics wet? Plastics often need towel drying.

Is the rinse aid dispenser empty? Refer to the "Rinse Aid

Dispenser" section.

Did you use an air-dry or energy-saving dry option? Use a

heated drying option for dryer dishes.