Avantco CFD-2FF 사용자 설명서 - 페이지 2

{카테고리_이름} Avantco CFD-2FF에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Avantco CFD-2FF 6 페이지.

User Manual

Installation

Please read this manual thoroughly prior to equipment set-up, operation and maintenance.

Important!!! Please Read Before Installation

• If the unit has recently been transported on its side, please let the unit stand upright for a

minimum of 24 hours before plugging it in.

• Make sure the unit has reached the desired temperature before loading the unit with products.

• Make sure all accessories are installed (shelves, shelf clips, etc...) before plugging in the unit.

• Do not attempt to remove or repair any component of the unit. Consult an authorized service

technician for servicing / repair.

• Do not hang on doors or stand inside the unit.

• Please read through this manual in its entirety.

Field Convertible Doors

The Avantco CFD1RR and CFD1FF both ship with a right-hinged door design. If you would like to

convert the reach-in to a left hinged door design, you must purchase the bottom hinge seperately

(Avantco item #00215765) and follow these instructions:

Tools Needed:

Socket Set

Pliers

Adjustable Wrench

Phillips Head Screwdriver

1. Remove the bottom vent, which is held on by loosening the 4 Phillips head screws that hold it on.

You do not need to remove the whole way, as the vent will slide up and out.

2. Remove the top panel next. It is held on with 2 small screws. Once the screws are out, the top

panel will hinge up.

3. Remove the small Philips head screws at the top and bottom door hinge where it attaches to the

brackets. Be careful not to lose the small washers.

4. Next take off the top bracket. It is held on with 3 bolts.

5. The door should come off at this point.

- Note: Do not lose the small round brass spacer on the bottom hinge!

6. Remove the bottom bracket. It is held on with 3 bolts.

- 2 -