HIKVISION U7T Series 사용자 설명서 - 페이지 9

{카테고리_이름} HIKVISION U7T Series에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. HIKVISION U7T Series 15 페이지. Turbo hd bullet & turret camera

1). Hold the camera body and rotate the enclosure to

adjust the pan position [0° to 360°].

2). Move the camera body up and down to adjust the

tilt position [0° to 75°].

3). Rotate the camera body to adjust the rotation

position [0° to 360°].

2.2.2 Ceiling Mounting with Junction Box

Before you start:

You need to purchase a junction box separately.



Both wall mounting and ceiling mounting are suitable



for the turret camera. Ceiling mounting will be taken as

an example in this section. And you can take steps of

ceiling mounting as a reference for wall mounting.

Steps:

1. Paste the junction box's drill template on the ceiling.

2. Drill screw holes and the cable hole (optional) in the

ceiling according to the holes of the drill template.

Figure 2-13 Drill Template of the Junction Box

Note:

Drill the cable hole, when adopting the ceiling outlet

to route the cable.

3. Refer to step 3 of 2.2.1 Ceiling Mounting without

Junction Box to take out the camera's main body.

4. Take apart the junction box, and align the screw holes

of the camera with those on the junction box's cover.

5. Fix the camera's mounting base on the junction box's

cover with three PM4 × 10 screws.

Figure 2-14 Secure Screws on Junction Box's Cover

6. Secure the junction box's body on the ceiling with four

PA4 × 25 screws.

Figure 2-15 Secure the Junction Box's Body on Ceiling

7. Combine the junction box cover with its body by

tightening four screws on junction box's cover.

8. Repeat steps 5 to 9 of 2.2.1 Ceiling Mounting without

Junction Box to complete the installation.

Figure 2-16 Fix the Junction Box