Avantco GDS47 사용자 설명서 - 페이지 3

{카테고리_이름} Avantco GDS47에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Avantco GDS47 5 페이지. Commercial refrigerator and freezer

Electrical

• Please ensure that the required voltage is being supplied at all times.

• The unit should be plugged into a grounded and properly-sized electrical outlet with appropriate over-

current protection. Please refer to the electrical requirements on the unit's nameplate.

• The unit should have its own dedicated outlet.

• Do not use extension cords.

• Ensure the unit is not resting on or against the electrical cord.

• If the unit is not in use for a long period of time, please unplug the unit from the outlet.

• To avoid shock and fire hazards, do not plug in or unplug the unit with wet hands.

• After unplugging the unit, wait at least 10 minutes before plugging it back in. Failure to do so could cause

damage to the compressor.

Temperature Controls

Adjusting the Temperature

Digital Control Units

Refrigerators are programmed to operate

between 32 and 41 degrees Fahrenheit.

Freezers are programmed to operate between 0 and +5 degrees Fahrenheit. To set the temperature you

would like your unit to run at, follow these instructions:

1) Hold "SET" for 1 sec. The display will flash the temperature that the refrigerator is currently set to run at.

2) Use the arrow buttons to adjust the temperature you want it to run at.

3) Press "SET" again to save your settings. If the unit consistently runs 5 + degrees higher than your set

temperature, service may be needed.

Mechanical Control Units

Adjust the control knob located inside the unit. The temperature can be adjusted from 7 (coldest) to 1

(warmest). Setting the temperature control to the coldest setting for a prolonged period of time may cause

the evaporator coil to freeze and ice up, which can cause damage to the unit.

NOTE: All other temperature control functions should only be used by an authorized service technician.

User Manual

- 3 -