Briteq BEAMSPOT1-DMX WW 운영 매뉴얼 - 페이지 5

{카테고리_이름} Briteq BEAMSPOT1-DMX WW에 대한 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Briteq BEAMSPOT1-DMX WW 12 페이지.

페이지 인쇄

ENGLISH

DESCRIPTION:

1. MAINS INPUT: equipped with original Neutrik PowerCON

PowerCon

extension cable here.

2. MAINS OUTPUT: used to daisy chain the power to several other projectors. Always pay attention to the

maximum load while adding projectors! Special Multi cables (PowerCON

optionally available: see our website!)

3. DMX IN: used to daisy chain the projector with other units that will be controlled by a DMX-controller. The

DMX-input is also used to update the firmware of the projector, see the upgrade instructions on our

website.

4. DMX OUT: used to daisy chain the projector with other units that will be controlled by a DMX-controller.

5. DISPLAY: shows the various menus and the selected functions:

6. MENU-button: used to browse the different menu options or to exit a menu option.

7. ENTER-button: used to select a menu option or confirm a setting.

8. ▲-button: used to go to the previous menu option or to increase a parameter value.

9. ▼-button: used to go to the next menu option or to decrease a parameter value.

10. SAFETY EYE: used to attach a safety cable when the unit is rigged, see paragraph "overhead rigging".

11. FROST FILTERS: 2 filters (10° and 45°) are included to make the very narrow 4° beam wider. Use the

metal ring to fix one of these filters in front of the 4° lens.

12. HANGING BRACKET: with a knob on both sides to fasten the unit in the desired position. you can use

the hole in the center of the bracket to fix a hook or truss clamp.

OVERHEAD RIGGING

Important: The installation must be carried out by qualified service personal only. Improper

installation can result in serious injuries and/or damage to property. Overhead rigging requires

extensive experience! Working load limits should be respected, certified installation materials should

be used, the installed device should be inspected regularly for safety.

 Make sure the area below the installation place is free from unwanted persons during rigging, de-rigging

and servicing.

 Locate the fixture in a well ventilated spot, far away from any flammable materials and/or liquids. The

fixture must be fixed at least 50cm from surrounding walls.

 The device should be installed out of reach of people and outside areas where persons may walk by or be

seated.

 Before rigging make sure that the installation area can hold a minimum point load of 10times the device's

weight.

 Always use a certified safety cable that can hold 12times the weight of the device when installing the unit.

This secondary safety attachment should be installed in a way that no part of the installation can drop

more than 20cm if the main attachment fails.

 The device should be well fixed; a free-swinging mounting is dangerous and may not be considered!

 Don't cover any ventilation openings as this may result in overheating.

 The operator has to make sure that the safety-relating and machine-technical installations are approved by

an expert before using them for the first time. The installations should be inspected every year by a skilled

person to be sure that safety is still optimal.

BRITEQ

. Connect the supplied mains cable or any

3/9

BEAMSPOT1-DMX NW (WW)

OPERATION MANUAL

+ DMX XLR-cables are